Bosch Appliances NDN-265-PIO installation manual Installation, Disassembly

Page 12

12 en Installation

IP Camera 200 Series

 

 

3Installation

3.1Disassembly

The camera/housing consists of the following parts:

x4

1.Dome

2.Inner liner

3.Camera module and mounting base

To disassemble the unit proceed as follows:

1.Using the special screwdriver bit supplied, loosen the four tamper-resistant screws in the dome (the screws remain in place).

2.Remove the dome from the base.

3.Remove the inner liner by pulling it off the base.

AM18-Q0616 v1 2012.02

Installation Manual

Bosch Security Systems

Image 12
Contents IP Camera 200 Series Page Table of Contents Maintenance Technical DataSafety Safety precautionsImportant safety instructions FCC & Ices compliance FCC & Ices InformationUL certification Bosch noticesDisclaimer More informationCopyrights Features IntroductionUnpacking CD ROMInstallation DisassemblyMicroSDHC card Network and power connector RJ45 Ethernet PoEPower connection DC power connectionI/O connector Function Wire ColorAudio connectors Audio connectorsMounting Mounting the cameraCamera set-up Camera positioning IP Camera 200 Series Installation en Focal length and focus Resetting the camera Browser connection System requirementsPassword protection in camera Establishing the connectionProtected network Troubleshooting Resolving problemsCustomer service Malfunction Possible causes SolutionMaintenance RepairsTransfer and disposal Technical Data SpecificationsIP Camera 200 SeriesTechnical Data en Accessories Page Bosch Security Systems