IP Camera 200 Series | Installation en 15 |
|
|
3.4Power connection
The camera can accept power from both the DC12V power input and the Ethernet input at the same time. You can remove either one of the power sources without interrupting camera operation.
3.4.1DC power connection
5 mm
(0.2 in)
22AWG
12 VDC
Figure 3.2 DC power connection
Connect power from a 12 VDC class 2 power supply as follows:
1.Use AWG22 wire; cut back 5 mm (0.2 in) of insulation.
2.Remove the
3.Loosen the screws and insert the wires.
4.Tighten the screws and reconnect the
Bosch Security Systems | Installation Manual |