Bosch Appliances NDN-265-PIO installation manual Network and power connector, RJ45 Ethernet PoE

Page 14

14 en Installation

IP Camera 200 Series

 

 

3.3Network (and power) connector

RJ45

Ethernet (PoE)

Figure 3.1 Network connection

Connect the camera to a 10/100 Base-T network.

Use a shielded UTP Category 5e cable with RJ45 connectors.

Power can be supplied to the camera via the Ethernet cable compliant with the Power-over-Ethernet

(IEEE 802.3af) standard.

CAUTION!

This equipment is only to be connected to PoE networks without routing to outside plant.

AM18-Q0616 v1 2012.02

Installation Manual

Bosch Security Systems

Image 14
Contents IP Camera 200 Series Page Table of Contents Maintenance Technical DataSafety Safety precautionsImportant safety instructions FCC & Ices compliance FCC & Ices InformationDisclaimer UL certificationBosch notices More informationCopyrights Features IntroductionUnpacking CD ROMInstallation DisassemblyMicroSDHC card Network and power connector RJ45 Ethernet PoEPower connection DC power connectionI/O connector Function Wire ColorAudio connectors Audio connectorsMounting Mounting the cameraCamera set-up Camera positioning IP Camera 200 Series Installation en Focal length and focus Resetting the camera Browser connection System requirementsProtected network Password protection in cameraEstablishing the connection Customer service TroubleshootingResolving problems Malfunction Possible causes SolutionTransfer and disposal MaintenanceRepairs Technical Data SpecificationsIP Camera 200 SeriesTechnical Data en Accessories Page Bosch Security Systems