Bosch Appliances NDN-265-PIO installation manual FCC & Ices compliance, FCC & Ices Information

Page 7

IP Camera 200 Series

Safety en

7

 

 

 

1.3FCC & ICES compliance

FCC & ICES Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

reorient or relocate the receiving antenna;

increase the separation between the equipment and receiver;

connect the equipment into an outlet on a circuit different from that to which the receiver is connected;

consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.this device may not cause harmful interference, and

2.this device must accept any interference received, including interference that may cause undesired operation.

Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made. Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action.

Bosch Security Systems

Installation Manual

AM18-Q0616 v1 2012.02

Image 7
Contents IP Camera 200 Series Page Table of Contents Technical Data MaintenanceSafety precautions SafetyImportant safety instructions FCC & Ices Information FCC & Ices complianceMore information UL certificationBosch notices DisclaimerCopyrights Introduction FeaturesCD ROM UnpackingDisassembly InstallationMicroSDHC card RJ45 Ethernet PoE Network and power connectorDC power connection Power connectionFunction Wire Color I/O connectorAudio connectors Audio connectorsMounting the camera MountingCamera set-up Camera positioning IP Camera 200 Series Installation en Focal length and focus Resetting the camera System requirements Browser connectionEstablishing the connection Password protection in cameraProtected network Malfunction Possible causes Solution TroubleshootingResolving problems Customer serviceRepairs MaintenanceTransfer and disposal Specifications Technical DataIP Camera 200 SeriesTechnical Data en Accessories Page Bosch Security Systems