IP Camera 200 Series | Installation en 25 |
|
|
3.9Resetting the camera
If the camera cannot be connected because the IP address has changed, press and hold the reset button (7 seconds approximately) until the LED flashes (red) to recall the factory default values. The factory default IP address is 192.168.0.1
Figure 3.7 Reset button
3.10Closing the unit
When the camera position is set and all adjustments have been made, close the unit.
1.Remove the monitor cable from the jack socket. (Ensure focus aid has been removed.)
2.Click the inner liner in position aligning the opening with the lens.
3.If necessary clean its surface with a soft cloth.
4.Align the LED light guide of the dome with the opening at the front of the mounting base and slot it home.
5.Use the supplied special screwdriver bit to tighten the two
Bosch Security Systems | Installation and Operation Manual |