Axis Communications axis q6042s ptz dome network camera Storage, UPnPTM, RTP/H.264, Bonjour

Page 52

AXIS Q6042–S PTZ Dome Network Camera

System Options

Note

If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.

Traps for SNMP v1/v2 are used by the Axis product to send messages to a management system on important events and status changes. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community that should receive the message.

The following traps are available:

•Cold start

•Warm start

•Link up

•Authentication failed

SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.

To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 45. To enable SNMP v3, check the box and provide the initial user password.

Note

The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see Reset to Factory Default Settings, on page 56.

UPnPTM

The Axis product includes support for UPnPTM. UPnPTM is enabled by default and the product is automatically detected by operating systems and clients that support this protocol.

UPnPTM can be disabled under System Options > Network > UPnPTM.

RTP/H.264

The RTP port range and multicast settings are configured under System Options > Network > RTP.

The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, only certain IP addresses and port numbers should be used.

Select Always Multicast Video to start multicast streaming without opening an RTSP session.

Bonjour

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating systems and clients that support this protocol.

Bonjour can be disabled under System Options > Network > Bonjour.

Storage

SD Card

The Axis product supports SD cards with up to 64 GB of storage. For best recording performance, use an SDHC or SDXC card with speed class 10.

NOTICE

To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.

The Axis product supports SD cards with the following file systems:

52

Page 51 Page 53
Image 52
Page 51 Page 53
Contents Axis Q6042-S PTZ Dome Network Camera About this Document Legal ConsiderationsLiability Intellectual Property RightsSupport Learn MoreTable of Contents Axis Q6042-S PTZ Dome Network CameraTechnical Specifications Hardware Overview Hardware OverviewPressurize the Camera Recommended Connectors and Buttons LED IndicatorsMulti-connector SD Card SlotHardware Overview Media Converter Switch Media Converter Switch ConnectorsDip switch position Network Connector Dip SwitchesConnector internal 2-pin I/O terminal block Media Converter Switch LED Indicators DescriptionAccessing the Product Accessing the ProductAccess from a Browser Start a browser Internet Explorer, Firefox, SafariSet the Root Password Accessing the Product Access from the InternetClick Use Https Accessing the Product Live View Go to Setup EventsControls on the Live View Manual TriggerAxis Media Control viewer toolbar PTZ ControlsAxis Q6042-S PTZ Dome Network Camera How to Stream H.264 Media StreamsMedia Streams Axis Media Control AMCAlternative Methods of Accessing the Video Stream QuickTimeTM. The following paths can be usedAxis Q6042-S PTZ Dome Network Camera Setting Up the Product Setting Up the ProductBasic Setup Video VideoVideo Stream Pixel CounterClick Save to apply the new settings Stream ProfilesImage 264Camera Settings Exposure SettingsImage Appearance White BalanceImage Settings OverlayOverlay Image Go to Video Video Stream and select the Image tabPrivacy Mask Using Overlay Text in an Action RuleGo to Events Action Rules Axis Q6042-S PTZ Dome Network Camera Live View Config Live View ConfigDefault Viewer for Browsers Viewer SettingsUser Defined Links Output ButtonsGo to Setup Live View Config Preset Positions Go to PTZ Preset PositionsPTZ Pan Tilt Zoom PTZ Pan Tilt ZoomConfiguration PTZ Pan Tilt Zoom GatekeeperAutotracking Exclude AreasGuard Tour Tour RecordingTo add a guard tour To add a recorded tourAdvanced Osdi ZonesLimits Control Queue Operator Same as administrator but with lower priorityControls Set Up Motion Detection Windows DetectorsDetectors Shock DetectionMotion Detection Parameters Install Application ApplicationsApplications Application LicensesAxis Q6042-S PTZ Dome Network Camera Events EventsSetting Up an Action Rule SystemTime PTZ ControlFallback Action RecipientsRecipient Use with action Setting Up an Email Recipient SchedulesGo to Events Recipients and click Add Go to Events Schedules and click AddEvents Recurrences Go to Events Recurrences and click AddRecordings RecordingsRecording List Continuous RecordingLanguages LanguagesSystem Options System OptionsSecurity UsersCertificates IeeeGo to System Options Security Ieee Basic TCP/IP Settings Go to Setup System Options Security CertificatesDate & Time NetworkIPv4 Address Configuration IPv6 Address ConfigurationAssign IP Address Using ARP/Ping ARP/PingAdvanced TCP/IP Settings Axis Internet Dynamic DNS ServiceAxis Internet Dynamic DNS Service requires IPv4 DNS ConfigurationNTP Configuration Host Name ConfigurationLink-Local IPv4 Address NAT traversal port mapping for IPv4QoS Quality of Service FTPStorage UPnPTMRTP/H.264 BonjourNetwork Share Go to System Options Storage and click SD CardTo add a network share Go to System Options Storage Click Network ShareSystem Options Ports & Devices MaintenanceSupport Plain Config Logs & ReportsScripting File UploadSystem Options Reset to Factory Default Settings Multi-Connector Cable Multi-Connector CableFunction Pin wire Specifications Activated, floating unconnected when Drain, 100 mATroubleshooting TroubleshootingEmergency Recovery Procedure Checking the FirmwareSymptoms, Possible Causes and Remedial Actions Problems setting the IP addressWhen using ARP/Ping Product cannot be accessed from a browserProblems with streaming H.264 Product is accessible locally but not externallyBasic Video and image problems, general Video Camera SettingsStorage and disk management problems Media converter switchTechnical Specifications Technical SpecificationsFunction/group Specifications System Application Installation aidMaintenance Integration Programming InterfaceFunction/group Specifications General Casing PowerConnectors WeightCamera Connectors Technical Specifications Media Converter Switch ConnectorsExternal Connectors Performance Considerations Collector 100 mAM1.8

axis q6042s ptz dome network camera specifications

The Axis Q6042-S PTZ Dome Network Camera is a sophisticated device designed for high-performance surveillance in diverse environments. With its robust construction and advanced features, this camera is ideal for use in critical areas such as airports, train stations, and city surveillance, ensuring reliable monitoring and security.

One of the standout features of the Axis Q6042-S is its high-definition image quality. The camera offers a resolution of up to 720p, allowing for clear and detailed video capture. This is further enhanced by its powerful zoom capabilities, featuring a 36x optical zoom lens. This enables users to focus on distant objects without sacrificing image quality, making it easy to identify individuals or objects of interest.

The pan-tilt-zoom (PTZ) functionality of the Axis Q6042-S is another significant characteristic. The camera can pan 360 degrees continuously and tilt from -20 to 90 degrees. This extensive range of motion provides complete coverage of the surveillance area, allowing operators to track fast-moving objects efficiently. Additionally, with preset positions, users can quickly move to key areas of interest, streamlining the monitoring process.

For versatility in different lighting conditions, the camera includes features such as day/night functionality and Axis' Lightfinder technology, which enhances its ability to capture color images in low-light environments. The advanced image processing capabilities ensure that the video remains clear and detailed, regardless of the lighting conditions.

Another technological advantage of the Axis Q6042-S is its advanced compression technologies, including H.264 and Motion JPEG. These technologies allow for efficient video streaming, reducing bandwidth and storage requirements without compromising video quality. The camera also supports Power over Ethernet (PoE), simplifying installation by allowing both power and data to be delivered over a single cable.

Moreover, the Axis Q6042-S is equipped with built-in analytics capabilities, enabling it to detect motion and trigger alerts based on predefined parameters. This intelligent functionality not only enhances security but also reduces the need for constant monitoring, allowing operators to focus on critical events.

In summary, the Axis Q6042-S PTZ Dome Network Camera stands out with its high-definition imaging, extensive PTZ capabilities, low-light performance, advanced compression technologies, and built-in analytics. Its robust design and versatile features make it an excellent choice for any surveillance application requiring precision, reliability, and ease of use.
Top Page Image Contents