AXIS 233D - System Options 51
About
Third Party Software Licenses - click View licenses for a list of the licensed software used in the AXIS 233D Network Dome Camera.
Resetting to Factory Default Settings
To reset the AXIS 233D to the original default settings, go to the System Options > Maintenance web page (described in Maintenance, on page 48) or use the control button on the AXIS 233D as described below:
Red Restart Button
Black Control Button 
Status LED Indicator 
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1.Remove dome of camera. See Installation Guide for instructions.
2.Press and hold the red and black button at the same time. Release the red restart button, but continue to hold down the black control button.
3.Keep the black control button pressed until the status indicator flashes amber (this may take up to 15 seconds).
4.Release the black control button.
5.When the status indicator displays green (which can take up to 1 minute) the process is complete and the camera has been reset to factory default.
6.