About the dehumidifying device

•The camera has dehumidifying device to keep the inside at low moisture level, preventing condensation and quickly dis- sipating dew if produced.

•Dew may be produced depending on the conditions of temperature, humidity, winds, and rain, and it may take time to dehumidify.

•Never seal the surfaces of the dehumidi- fying device.

Dehumidifying device

Turn the circuit breaker off which supplies the camera with the power when abnormal conditions are encountered.

Observe the following for installation.

•This apparatus is designed to be installed under eaves. Install this appara- tus under eaves to avoid direct sunlight.

•If this apparatus is installed outdoors without eaves, ensure the same circum- stances as being under eaves.

Avoid installing in the following locations.

•Locations where a chemical agent is used such as a swimming pool

•Locations subject to steam and oil smoke such as a kitchen

•Locations near flammable gas or vapor

•Locations where radiation or x-ray emis- sions are produced

•Locations subject to strong magnetic field or radio waves

•Locations where corrosive gas is pro- duced

•Locations where it may be damaged by briny air such as seashores

•Locations where the temperature is not within –10 °C - +50 °C.

•Locations subject to vibrations (This product is not designed for on-vehicle use.)

Installing place

Contact your dealer for assistance if you are unsure of an appropriate place in your partic- ular environment.

Make sure that the installation area is strong enough to hold the camera, such as a con- crete ceiling.

When the installation area is not strong enough, reinforce and strengthen it or use Mounting Bracket (WV-CW484F: option, WV- CW480S: provided) or Ceiling Mount Bracket. (Refer to p. 46 Optional Acces- sories.).

Do not install the camera in a humid or dust-laden environment.

Otherwise, lifetime of the internal parts may be shortened.

Be sure to remove this apparatus if it is not in use.

Radio interference

When the camera is used near TV/radio antenna, strong electric field or magnetic field (near a motor or a transformer), images may be distorted and noise sound may be produced.

Mounting screws

Only the fixing screws are provided to fix the camera with the provided mounting bracket. It is necessary to procure screws or bolts to mount the camera. Prepare them according to the material and strength of the area where the camera is to be installed. The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area.