Panasonic WV-CW480S operating instructions Lens, Back-focus Setting BACK-FOCUS Setup

•Image stabilization may not function where there is excessive camera movement or when the scene is low light or low contrast objects.

16. LENS

Select PANASONIC.

17. Back-focus Setting (BACK-FOCUS SETUP)

Perform adjustment of the back-focus (flange- back: the gap between the lens and focal plane) remotely on this menu using a system controller. After installation, you can perform this adjustment when defocus arises that may be caused by long-term use, environmental changes, etc.

Important: Do not use the ABF function for con- tinuous or repetitive purposes (ex. autofocus etc.). This function is to be used to correct defocus caused by switching between colour and black - and - white when/after installing the camera.

**BACK-FOCUS SETUP**
ABF	→PUSH SW
MANUAL-ADJ↵
C/L← → B/W	AUTO
SETUP-SW LOCK OFF
NEAR	FAR

.........I.........

INDICATOR XXXX RET TOP END

1.Select BACK-FOCUS on the top menu and press the [SET] button.

→The BACK-FOCUS SETUP menu opens.

2.Select ABF and press the [SET] button.

→Adjustment is automatically performed.

Notes:

•Performing ABF will function to obtain the best focus around the centre areas in a scene.

•Performing ABF is available only when OFF, X2 AUTO, or X2 FIX is selected for SENS UP.

•Using the ABF function under low light conditions may cause noise.

3.Select MANUAL-ADJ and press the [SET] button if manual adjustment is required. The manual back-focus adjustment screen will open.

•Use the [LEFT] or [RIGHT] buttons to move the "I" cursor and obtain a proper focus.

→Refer to the 4-digit number on the second bottom line. The larger the number is, the bet- ter the focus will be.

•Select RET and press the [SET] button to go back to the menu setup.

39