Page 6 | AXIS |
Connect the cables
1.Connect the camera to the network using a shielded network cable.
2.Optionally connect external input/output devices, e.g. alarm devices. See page 14 for information on the terminal connector pins.
3.Optionally connect an active speaker and/or external microphone.
4.Connect power, using one of the methods listed below:
•PoE (Power over Ethernet). If available, this is automatically detected when the network cable is connected (see above).
•Connect the supplied indoor power supply to the power connector on the camera.
5.Check that the indicator LED:s indicate the correct conditions. See the table on page 15 for further details. Note that some LEDs can be disabled and may be unlit.