Cisco Systems 3120 manual Removing a Module, Installing X2 Transceiver Modules

Chapter 2 Switch Installation

Installing Devices in the 10-Gigabit Ethernet Slots

Figure 2-12 Installing X2 Transceiver Modules

SYST S-MODE S-MSTR S-MMBR

UID

MODE

CONSOLE

19-20

23x

22 24x

26x

	STK A
WS-	STK B
CBS312	0G-S

250299

Caution Do not install the converter module with SFP modules or cables installed. Always remove any cables and modules before installing the converter module in the slot.

Figure 2-13 Installing Converter Modules

SYST S-MODE S-MSTR S-MMBR

UID

MODE CONSOLE

19-20

23x

SFP 21-22 24x

26x

	STK A
WS-	STK B
CBS312	0G-S

250300

Removing a Module

To remove an X2 transceiver module or a converter module, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Step 2 For X2 transceiver modules, disconnect the cables from the module. For fiber-optic modules, install the optical bore dust plugs.

Step 3 For converter modules, disconnect the cables from the SFP module. Remove the SFP modules from the converter module.

Caution Do not remove the converter module with SFP modules or cables installed. Always remove any cables and modules before removing the converter module from the slot.

Step 4 Carefully pull on the X2 module sleeve, or pinch the tabs on the converter module to disengage it from the slot. Grasp the edges of the module, and carefully slide it out of the slot.

	Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01		2-19