Cisco Systems 3120 manual These choices appear

Appendix C Configuring the Switch with the CLI-Based Setup Program

Accessing the CLI Through the Console Port

!

interface Vlan1 no shutdown

ip address 10.0.0.1 255.255.255.0

!

interface GigabitEthernet0/1

!

interface GigabitEthernet0/2

. . . (output truncated)

interface GigabitEthernet0/16

!

end

Step 10 These choices appear:

[0]Go to the IOS command prompt without saving this config.

[1]Return back to the setup without saving this config.

[2]Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Step 11 Disconnect the blade server serial port or the switch module console port from the PC. See the “Management Options” section on page 1-8for information about managing the switch module.

Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide

C-6 OL-12246-01