Cisco Systems 3120 manual Setup

Contents

	Installing the Switch Module in the Blade Enclosure						6
	Switch Module IP Addresses			8
	Using the Onboard Administrator to Assign an IP Address to the Switch Module and Running Express
	Setup 9
	Using Express Setup		11
	Setting the Installed Switch Module As the Stack Master 12
	Refreshing the PC IP Address			13
	Planning and Creating a Switch Stack				13
	Stack Cabling Configurations			14
	Connecting to the StackWise Plus Ports					16
	Installing Devices in the 10-Gigabit Ethernet Slots						17
	Installing X2 Transceiver Modules and Cisco Converter Modules 18
	Installing SFP Modules 20
	Connecting to the 10/100/1000 Ports				22
	Planning 10/100/1000 Ethernet Port Connections						23
	Where to Go Next	24
	Troubleshooting 1
C H A P T E R 3
	Diagnosing Problems	1
	Verify the Switch Module POST Results					1
	Look at the Switch Module LEDs				2
	Confirm the Switch Module Connections					2
	Verify the Switch Module Performance					4
	Clearing the Switch Module IP Address and Configuration 5
	Replacing a Failed Stack Member			5
	Locating the Switch Module Serial Number					6
	Technical Specifications
A P P E N D I X A			1
	Connector and Cable Specifications
A P P E N D I X B					1
	Connector Specifications		1
	10/100/1000 Ports		1
	10-Gigabit Ethernet Module Interfaces					3
	Cisco TwinGig Converter Module Ports					3
	Console Port 4

Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide

4 OL-12246-01