Samsung SHR-5162, SHR-5082 user manual Checking Installation Environment, HDD Addition

Page 12

installation

You should pay attention to the following before you use the product.

Do not use it outdoor.

Do not place water or liquid near the connection part or the product.

Do not impose excessive shock or force.

Do not pull out the power cord unreasonably.

Do not disassemble the product on your own.

Do not exceed the rated input or output voltage range.

Use the certified power cord only.

For the product with an input ground, use a power plug with a ground pin.

CHECKING INSTALLATION ENVIRONMENT

Samsung Digital Video Recorder (hereinafter referred to “DVR”) is a high-tech security equipment that contains a high-capacity HDD and top-notch circuits. High temperature inside or outside of the product may reduce the product life, deteriorate performance (see the graph below; it explains the correlation between temperature and product life), and lead to a malfunction.

Temperature

One Year: 24HR X 365 DAY =8,760 HR

Unit: ºC

 

Life (Unit: HOURS)

Figure 1

Please keep the following instructions for rack- mounting the Samsung DVRs to proceed with the installation.

1.The rack on which the DVR is mounted should not be sealed off.

2.And it also can allow air circulation through the vent.

3.As shown in the Figure 2, we recommend you to heap the product with other DVRs or use rack-mount devices at a certain space, or install a vent system to accommodate airflow.

4.For forming a natural convection, the air intake hole should be positioned at the bottom and the emission at the top.

5.We recommend you to install each of the air intake and emission holes with fan motors for sufficient airflow. (The air intake fan should be equipped with a filter to prevent possible inflow of dust and other impurities.

6.As shown in the Figure 1, the temperature inside the rack and around the DVR should maintain between 0 and 40°C (32 and 104°F).

HDD ADDITION

The user can add up to two hard disks to this product. However, there are many factors that can cause electric shock, accidents, and malfunctioning of the device inside of the product.

When the user does not correctly install or apply the proper settings, the device may not recognize the hard disks or the device will not properly run. Therefore, before adding any hard disks, it is recommended that you consult the specialist from the site where you purchased the product.

Figure 2

08_ installation

SHR-5162_Eng.indb 8

2007-06-18 ｿﾀﾀ・11:47:44

 

 

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Real Time DVR Key features of your DVR WHAT’S Included with Your DVRSafety regulations Battery Operating TemperatureBefore start Standards ApprovalsContents Search and Play Introducing your real time DVR Controls on the DVRPower LED Fast/Step Rewind ButtonStop Button PLAY/PAUSE ButtonRear Panel Jacks RearRemote Control Press the 1 to 9 button respectivelyRelease, and wait 3 seconds FR fast rewind FR fast reverse Used forChanging the Remote Control ID Installation Checking Installation EnvironmentHDD Addition Things to consider when adding a hard disk Setting the jumperHow to add hard disks SlaveBracket Hddb Hdda ScrewdriverBRACKET-HDDB Connecting with other devices Connecting VIDEO, AUDIO, and Monitor Connecting the NetworkConnecting to Internet through Ethernet 10/100BaseT Illustrations are described based on SHR-5162Connecting the USB Connecting the Alarm INPUT/OUTPUTConnecting to Internet through Adsl  5082 Alarm IN/OUT Ports  5162 Alarm IN/OUT PortsConnecting the RS-485 Device Live Screen Mode LiveOperating the System Live screen iconsLive screen modes Setting Audio ON/OFF Selecting live screen modeAudio On/Off setting in full screen mode Audio On/Off setting in 16-split modeFreezing and Zooming Event MonitoringFreeze function Zoom functionFan Information Error occurs in the fan Refer to the manual SPOT-OUT MonitoringMenu setup Date/Time/Language SetupBefore USE SystemPassword Load Factory Default System LogEvent Log System Information and Setup Storage SetupExport/Import the Configuration Remote Control DeviceCamera Configuration CameraScreen Setup MonitoringPTZ Device Record Mode Record Quality & Auto DeletionRecord Rate & Video Size Event Record DurationEvent Record Mode Alarm Detection SetupMotion Detection Setup Video Loss Detection Setup ScheduleRecord Schedule Alarm Out Schedule IP SettingsNetwork Transfer Protocol Settings Callback Settings Transfer Picture SettingsCallback Settings Transfer Picture SettingsConfiguring Network Port configuration for connecting Smart Viewer Poor image problem in Smart Viewer Case of TCP transfer protocolBackup To configure the related settingsBackup PTZ Camera Control Mode PTZ camera controlBasic PTZ Operations Preset Setup Camera Menu SetupTo set a preset Preset View Other ViewSamsung PanRecording REC Normal RecordingRecord Schedule Search and play Calendar SearchEvent Search To perform a calendar searchDate Time Search GO to First SearchTo perform an event search To perform a date/time searchBackup Search Backup Search Can SelectGO to Last Search Playback Playback mode  Speed play Viewing still images  Audio playbackMain Features PC Specification RecommendedSmart Viewer IntroductionExecution Setup Mode This button is used for connecting to CallbackThis screen shows the monitoring sites DVR Setup  Setup Item Selection buttons Save/Cancellation of Revised Information  Closing the setup windowFor more details, see , Menu Setup Admin Password User PasswordCamera Configuration  Camera Only English is available for the title Retype it Monitoring Setup  Recording Schedule Network Password  For the network password, you can Network Viewer Setup Site Setup You can set the language to be displayed on Smart Viewer DVR List Smart Viewer, the following message appears If you really want to modify the DVR, disconnectDVR and retry to modify it  Site ListVersion To edit the DVR, go to the DVR listTo add a DVR to the site, select a DVR and click Add Monitoring Mode Password certification failureConnection Failure Cases Upgrading the DVR softwareMode Conversion Button Connection ScreenTime Information Connection Information Time Change When the date and time of the DVR are changed Event Log Display WindowClick Log to activate the log display window Sequence Mode Button  Black When Smart Viewer cannot be connected to a DVRCamera Connection Indication Window Screen Split Selection ButtonsNext Button Callback ButtonFavorite Button Video Recording ButtonAudio Volume Control Button Video Brightness/Contrast Control ButtonPTZ Camera Control Buttons Self Menu Setup of PTZ device  The other cameras do not support those functionsSearch Mode Remote Mode Audio Volume, Video Brightness/ Contrast ButtonsVideo Save Backup/Video Conversion/Print/Setup Calendar WindowViewer Setup File Converting Jpeg Location Viewer Setup File Converting AVI Location Print buttonSetup Mode button File Conversion buttonLocal Mode Time LineReload button It renews the recording time informationProduct Specification AppendixVideo MPEG4 True Recording ips 0.938/1.875/3.75/7.5/15/30ipsTrue Recording ips 0.781/1.563/3.125/6.25/12.5/25i 15ipsNTSC/12.5ipsPAL 5ipsNTSC/6.2ipsPALTriplex 16 split  15 Channel Live +1Channel PB Outline Drawings  5082 Outline Drawings 5162 Outline Drawings Factory Default Classification Detailed Items Factory SetupCH1 On / Off RetryOff Troubleshooting FAQ  If you forget the password, you shall reset the DVR to If all your efforts as above end up with nothing, check DVR has problem. DVR will not work in order to protect Works for the shop where you bought the product When you use DHCP/ADSLPPPoE for connection  Check if 3 Smart Viewer users are in connection with Make sure that the additional external HDD installed  Make sure that the external storage device installed isOpen Source License Report on the Product PreambleAppendix No Warranty How to Apply These Terms to Your New Programs Repair or CorrectionWe protect your rights with a two-step method You must cause the whole of the work to SHR-5162Eng.indb 2007-06-18 ｿﾀﾀ・115043 Executable How to Apply These Terms to Your New Libraries FoundationLicense, or at your option any later version OpenSSL License Loss of USE, DATA, or Profits or Business InterruptionThis Software is Provided by Eric Young ‘‘AS IS’’
Related manuals
Manual 1 pages 37.83 Kb
Top Page Image Contents