Samsung SHR-5162, SHR-5082 user manual Monitoring, PTZ Device, Screen Setup

PTZ Device

You can configure the PTZ device related settings.

PTZ Device

Cam	ID	Protocol	Baudrate	Parity	Data	Stop
1	000n	Samsung	38400	None	8	1
2	001	Vic.	38400	None	8	1
3	002	Pan.	19200	None	8	1
4	003	Dia.	38400	Even	8	1
5	004	None	38400	None	8	1
6	005	None	38400	None	8	1
7	006	None	38400	None	8	1
8	007	None	38400	None	8	1
Serial Mode		:
Half Duplex			9-16	OK		Cancel

ID

ID for PTZ camera. It can have any number among 0 to 255.

Protocol

Protocol that is supported by the PTZ device. Available protocols are Samsung, Vic., Pan., AD, Phi., Ern., Pel-D, Pel-P, Vcl., Dia., Kal., and Tech.

Baudrate

Available baud rates are 600, 1200, 2400, 4800, 9600, 19200, and 38400.

Parity

Select one of None, Even, and Odd.

Data

Select 7 or 8 for data bit.

Stop

Select 1 or 2 for stop bit.

Serial Mode

Select Half Duplex or Full Duplex for data exchanging method.

In case of SHR-5082, only 8 channels are displayed.

The above setting values must be the CAUTION same as the ones of the PTZ device.

For more details, please refer to the user manual for the PTZ device.

26_ menu setup

Screen Setup

It is used to set the brightness, contrast, and color for the camera image of each channel.

Brightness 050

Contrast 050

Color 050

Default Exit

Place the cursor on the channel that you want to set the values for brightness, contrast, and color. When a channel is selected, its image appears on the right. For selection, press the ENTER button. Use the UP/DOWN direction buttons to change the value from 0 to 100.

When Default is selected, the value 50 is to be assigned for each item of the selected channel.

In case of SHR-5082, only 8 channels are displayed.

MONITORING

You can configure the monitoring-related settings.

Monitoring

Event Monitoring	Duration	Off
OSG Display	Date	On
	Time	On
	Title	On
	Status	On
Spot Out Channel	CH1
Spot Out Event Monitor	Off
Monitor Out	Dual OUT
PB Channel Position	Right Down
Multi Channel Seq.	5sec
		OK	Cancel

Event Monitoring

You can select any of Off, 3sec, 5sec, 10sec, 20sec, 30sec, and Continuous.

-Off: Event monitoring does not work.

-3sec, 5sec, 10sec, 20sec, and 30sec: Sets the screen duration period in the Auto Sequence (or auto sequence) mode.

-Continuous: The event monitoring screen remains alive until you press the ALARM button.

SHR-5162_Eng.indb 26 2007-06-18 ｿﾀﾀ・11:48:22