Samsung SHR-5082, SHR-5162 user manual System Information and Setup, Storage Setup

System Information and Setup

System Information and Setup

System Information
Software Version	B3.07-K1.40-V2.17_0702101326
Broadcast Format	NTSC
Mac Address	00:00:FO:54:FF:FF

USB S/W Upgrade
Version	83.07-K1.40-V2.17C_0703141732
	OK	Cancel

This setup window provides the following setting items:

Software Version: Displays the current software version. The value cannot be changed.

Broadcast Format: Displays the current broadcast format (NTSC/PAL). The value cannot be changed.

Mac Address: 6-Byte hardware address. The value cannot be changed.

USB S/W Upgrade

You can update the software using a USB device. If there is no device, None is displayed. If the USB memory has an upgrade software, its version is displayed.

To upgrade the software stored in the USB device, select the check box on the right and press OK.

Storage Setup

You can configure the storage device related settings.

Storage Setup

Device Information
Device	No	Used/Total	Erase	Usage
ATA	1	295.00K/139.92G		Internal
USB Memory	1	0.00/494.98M		Backup
Disk End Mode			OverWrite
Disk End Beep			Off
			OK	Cancel

Device Information

Displays the number, capacity, and usage of ATA and USB devices. (The total capacity displayed may be lower than the actual capacity because the DVR uses some portion of it for internal purpose.) After selecting Erase for each device, you can remove the data on it. In case of USB device, you can set the usage for extension or backup. If you change the usage of the device, the stored data will be removed.

Disk End Mode

-Stop: Stops recording when the disk is full while recording is still in progress.

-Overwrite: Deletes the previously recorded data to store new data when the disk is full during recording.

Disk End Beep

-On: Beeps when the disk is full while recording.

-Off: Although the disk is full while recording, it doesn’t make beep sound.

HDD Installation Information

When you click ( ), The HDD Installation Information displays on the screen. Then you can see the model name, the capacity, and the status of the HDD in your DVR. The status displays Good, Not good, and Check. In the status of Not good, you should replace the HDD. In the status of Check, you should replace the HDD or check periodically. After clicking the Alarm Setup, you can set the alarm and the duration while the status is Not good or Check. If you click the HDD location map, it displays the information about the HDD installation. When a problem occurs, you can see which HDD has a problem.

The capacity of the HDD may differently appear in the Storage Setup menu and HDD Installation Information menu.

HDD Installation Information

No.	Model	Capacity	Status
1	ST3250823ACE	250.05G	Good
2	ST3160212ACE	160.04G	Good
3	DVD RW	-	-
4	ST3250823ACE	250.05G	Good

Alarm Setup HDD Location MapExit

Alarm Setup

NG	None
Duration	10 sec
Check	None
Duration	10 sec
	OK	Cancel

HDD Location Map

Exit

menu setup _23

05 MENU SETUP

SHR-5162_Eng.indb 23 2007-06-18 ｿﾀﾀ・11:48:14