Samsung SHR-5082, SHR-5162 Event Record Mode, Alarm Detection Setup, Motion Detection Setup

EVENT RECORD MODE

The detailed list for event mode settings is as follows:

MENU SETUP

System
Camera
Monitoring
Record Mode
Event Record	Alarm Detection Setup
Schedule	Motion Detection Setup
	Video Loss Detection Setup
Backup
Network
Move/Control	Select	MENU Exit

Alarm Detection Setup

Alarm Detection Setup

Sensor	State	Cam	Alarm-Out	Duration
1	Off	1	None	10sec
2	Off	2	None	10sec
3	Off	3	None	10sec
4	Off	4	None	10sec
5	Off	5	None	10sec
6	Off	6	None	10sec
7	Off	7	None	10sec
8	Off	8	None	10sec
		9-16	OK	Cancel

Sensor State

-Off: Sensor does not operate.

-N.O (Normal Open): Sensor remains open all the time. But if it gets closed, an alarm is issued. (A Contact)

-N.C (Normal Close): Sensor remains closed all the time. But if it gets open, an alarm is issued. (B Contact)

Cam

It is used to set a camera that synchronizes with the current sensor. The default setting follows the sensor number. A sensor can synchronize with multiple cameras so multiple values can be selected.

You can set a preset for each camera to synchronize sensors with cameras. If a sensor triggers the corresponding camera, the camera can show you the preset location.

Alarm-Out

It is used to set the Alarm-Out location when any alarm occurs. Currently 5 Alarm Outs are available. Select an alarm-out to synchronize with the current sensor. But multiple values can be selected.

Duration

It is used to set the Alarm-Out duration. When an alarm occurs, the alarm is output for the preset time. You can select any of Off, 3sec, 5sec, 10sec, 20sec, 30sec, and Continuous.

In case of SHR-5082, only 8 channels are displayed.

Motion Detection Setup

You can configure the motion detection related settings. When the detection area is set, the system detects any motion in that area.

Motion Detection Setup

Cam	M.D State	Area	Sensitivity	Alarm-Out	Duration
1	Off	Set	Very High	None	10sec
2	Off	Set	Very High	None	10sec
3	Off	Set	Very High	None	10sec
4	Off	Set	Very High	None	10sec
5	Off	Set	Very High	None	10sec
6	Off	Set	Very High	None	10sec
7	Off	Set	Very High	None	10sec
8	Off	Set	Very High	None	10sec
			9-16	OK	Cancel

M.D State

-Off: Motion detection does not operate.

-On: Motion detection is active.

Area

This is used to set the motion detection area. It is not allowed to set 4 extreme rows (Up, Down, Left, Right) because the display boundary regions can vary according to the monitor specification.

-Select All: Selects the whole area.

-Select One: Selects a block unit for each time.

-Select Quarter: Selects a quarter unit of the screen for each time.

-Clear All: Clears the whole selection.

-Save & Exit: Saves the setting and exits.

-Exit: Exits without saving.

Select All

Select One

Select Quarter

Clear All

Save & Exit

Exit

menu setup _29

05 MENU SETUP

SHR-5162_Eng.indb 29 2007-06-18 ｿﾀﾀ・11:48:28