Samsung SDE3004, SDE-3004 user manual Remote Devices, HDD Alarm

HDD Alarm

You can set alarm settings for HDD defects such as Check Alarm Output Port, Replace Alarm Output Port, and its duration.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Device> window to	Storage Device
	move to <Storage Device>, and press [ENTER] button.		Device	Format		HDD Alarm
2.	Select <HDD Alarm>.		 Check Alarm Output Port		BEEP
			 Duration		OFF
	A window for setting HDD check and replace output ports
	and their durations appears.		 Replace Alarm Output Port		BEEP		
							USING
3.			 Duration		OFF
	Use direction buttons (	) to move to the desired
	item.
• Alarm					OK	Cancel	THE
	- If <BEEP> was selected, a beep will sound.						DVR
• Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specified alarm
	output port.

•Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified alarm output port.

•Duration : Sets the alarm duration for the alarm signal and beep sound.

M <Check> status means that the HDD is operating but it has problems that require technical examination.

( ) appears on the Live screen.

<Replace> status means that the HDD has defect and requires immediate replacement.

( ) appears on the Live screen.

4.When the HDD Alarm setup is done, press <OK>.

Remote Devices

Specify the use of remote control and the remote control ID so that you can synchronize with the DVR.

Using the mouse may help make setup easier.

1. Use the up/down buttons ( ) in <Device> window to move to <Remote Device>, and press [ENTER] button.

2.Make sure to match IDs of the DVR, Remote Control and press <OK>.

M For changing the remote control’s ID, refer to “Changing the Remote Control ID”. (Page 12)

Remote Device

Remote Control ON

ID 0

OK Cancel

English _43