Active Thermal Management UVS-7111 manual Basic Setting Network PPPoE dial-up networking setting

UVS-7111 User's Manual Basic Setting

Basic Setting > Network > PPPoE (dial-up networking setting)

PPPoE: Point-to-Point Protocol over Ethernet is a protocol that supports access to a high-speed wideband network using a PC and a wideband modem (such as xDSL, Cable, Wireless modem). The user need only to equip the PC with an Ethernet card and apply to ISP (such as HiNet) and ADSL provider (such as Chunghwa Telecom) for ADSL service to roam the Internet through ordinary twisted copper wires.

PPPoE: Point to Point Protocol over Ethernet is applicable to networking via a xDSL or cable modem. PPPoE setting must be executed in the LAN environment for your PC to connect to ADSL. Follow the steps below to complete the setting:

1. Dial: You can select whether or not to dial when you boot the machine.

2. Use DHCP or fixed IP for connection to the LAN environment.

3. Key in the IP address of the camera and enter "PPPoE Setting" following the route Setting → Basic Setting → Network → PPPoE.

4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click Save to confirm the setting.

5.Where the ADSL modem and the camera is connected via a switch-hub, you can press “Reboot” or restart the machine manually to try PPPoE dialing

when the setting of the camera has been completed.

6.To observe the new IP address acquired when PPPoE dialing has been executed successfully, follow the route Setting → Basic Setting → Network

→Notification for the IP information. You can acquire the new IP address

via SMTP, FTP, and HTTP. Refer to the “Notification Setting” page for more information.

Note: You can use the DDNS function to access the camera. Refer to the “DDNS Setting” page for more information.

PPPoE setting

◦ Basic Setting > Network > PPPoE > PPPoE

Dial:

Username:

Password:

You can select whether or not to dial when you boot the machine (On Boot or Off).

Enter the username provided by your ISP. Enter the password.

◦Basic Setting > Network > PPPoE > PPPoE Information

IP Address: Subnet Mask:

Default Gateway:

DNS:

The IP address acquired when dialing has been executed successfully. The subnet mask information acquired when dialing has been executed successfully.

The gateway information acquired when dialing has been executed successfully.

The ISP domain name acquired when dialing has been executed successfully.

43