Philips MCM204 Before using the remote control, FM Antenna, Speakers Connection Front Speakers

Page 10

Preparations

English

FM Antenna

It is unnecessary to connect the FM pigtail antenna since it is fixed to the main unit.

Adjust the FM antenna for optimal FM stereo reception.

CSpeakers Connection

Front Speakers

Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", coloured (marked) wire to "+" and black (unmarked) wire to "-".

Before using the remote control

1Pull out the plastic protective sheet.

2Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD,TUNER).

3Then select the desired function (for example

É, í, ë).

1 2

Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

For optimal sound performance, use the supplied speakers.

Do not connect more than one speaker to any one pair of +/- speaker terminals.

Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Replacing battery (lithium CR2025) into the remote control

1Push to open the battery tray.

2Replace a new battery according to the indicated polarity.

3Push the battery tray back to close it.

CAUTION!

ÐRemove battery if they are exhausted or will not be used for a long time.

ÐBatteries contain chemical substances, so they should be disposed of properly.

10

Image 10
Contents Micro Hi-Fi System MCM204Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KPage Klass 1 laseraparat 139 101120 158Contents General Information Supplied accessoriesSafety Information Environmental InformationTo establish a safe volume level Hearing SafetyListen at a moderate volume Set your volume control at a low settingRear connections PowerPreparations MW AntennaFM Antenna Before using the remote controlReplacing battery lithium CR2025 into the remote control Speakers Connection Front SpeakersControls on the system and remote control Controls available on the remote control onlyPower-saving automatic standby Switching the system onBasic Functions Adjusting volume and sound Basic playback controls CD/MP3 OperationLoading a disc Playing an MP3 discReviewing the programme Different play modes Shuffle and RepeatProgramming track numbers Erasing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Programming radio stationsGeneral information on recording Synchro start CD recording Tape Operation / RecordingTape playback To select and record a particular passage within a CD trackRecording from the radio Other ConnectionListening to an external source Supported formats Using USB connectivityUSB Connection System will not play or support the followingInformation Regarding USB Direct Setting the timer Clock/TimerSetting the clock Activating and deactivatingSpecifications MaintenanceTroubleshooting Check the speaker connections and locationProperly Remote control does not functionClock/Timer setting is erased Time is not workingFrançais Meet Philips at the Internet