Philips MCM204 user manual General Information, Supplied accessories, Environmental Information

Page 7

General Information

Congratulations on your purchase and welcome to Philips!

To fully benefit from the support that Philips offers, register your product at www.philips.com/ welcome.

This product complies with the radio interference requirements of the European Community.

Supplied accessories

2 speaker boxes

remote control

MW loop antenna

Environmental Information

All unnecessary packaging has been omitted.We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Disposal of your old product

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out

wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC

Please inform yourself about the local separate collection system for electrical and electronic products.

Please act according to your local rules and do not dispose of your old products with your normal household waste.The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

Place the system on a flat, hard and stable surface.

Where the MAINS plug or an appliance coupler is used as the disconnet device, the disconnet device shall remain readily operable.

The apparatus shall not be exposed to dripping or splashing.

Install the unit near the AC outlet and where the AC power plug can be easily reached.

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

No naked flame sources, such as lighted candles, should be placed on the apparatus.

No objects filled with liquids, such as vases, shall be placed on the apparatus.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

7

Image 7
Contents MCM204 Micro Hi-Fi SystemCopyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plugPage Klass 1 laseraparat 158 101120 139Contents Environmental Information Supplied accessoriesSafety Information General InformationSet your volume control at a low setting Hearing SafetyListen at a moderate volume To establish a safe volume levelMW Antenna PowerPreparations Rear connectionsSpeakers Connection Front Speakers Before using the remote controlReplacing battery lithium CR2025 into the remote control FM AntennaControls available on the remote control only Controls on the system and remote controlPower-saving automatic standby Switching the system onBasic Functions Adjusting volume and sound Playing an MP3 disc CD/MP3 OperationLoading a disc Basic playback controlsErasing the programme Different play modes Shuffle and RepeatProgramming track numbers Reviewing the programmeProgramming radio stations Tuning to radio stationsTuning to preset radio stations Radio ReceptionTo select and record a particular passage within a CD track Tape Operation / RecordingTape playback General information on recording Synchro start CD recordingRecording from the radio Other ConnectionListening to an external source System will not play or support the following Using USB connectivityUSB Connection Supported formatsInformation Regarding USB Direct Activating and deactivating Clock/TimerSetting the clock Setting the timerMaintenance SpecificationsCheck the speaker connections and location TroubleshootingTime is not working Remote control does not functionClock/Timer setting is erased ProperlyMeet Philips at the Internet Français