Philips MCM204 user manual Troubleshooting, Check the speaker connections and location

Page 23

Troubleshooting

WARNING

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.

English

Problem

NO DISC” is displayed.

Radio reception is poor.

Recording or playback cannot be made.

The system does not react when buttons are pressed.

Sound cannot be heard or is of poor quality.

The left and right sound outputs are reversed.

Solution

Insert a disc.

Check if the disc is inserted upside down.

Wait until the moisture condensation at the lens has cleared.

Replace or clean the disc, see “Maintenance”.

Use a finalized CD-RW or a correct MP3-CD format disc.

If the signal is too weak, adjust the antenna or connect an external antenna for better reception.

Increase the distance between the Mini HiFi System and your TV or VCR.

Clean deck parts, see “Maintenance”.

Use only NORMAL (IEC I) tape.

Apply a piece of adhesive tape over the missing tab space.

Remove and reconnect the AC power plug and switch on the system again.

Adjust the volume.

Disconnect the headphones.

Check that the speakers are connec ted correctly.

Check if the stripped speaker wire is clamped.

Make sure the MP3-CD was recorded within 32-256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz.

Check the speaker connections and location.

23

Image 23
Contents MCM204 Micro Hi-Fi SystemCopyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plugPage Klass 1 laseraparat 158 101120 139Contents Environmental Information Supplied accessoriesSafety Information General InformationSet your volume control at a low setting Hearing SafetyListen at a moderate volume To establish a safe volume levelMW Antenna PowerPreparations Rear connectionsSpeakers Connection Front Speakers Before using the remote controlReplacing battery lithium CR2025 into the remote control FM AntennaControls available on the remote control only Controls on the system and remote controlBasic Functions Switching the system onPower-saving automatic standby Adjusting volume and sound Playing an MP3 disc CD/MP3 OperationLoading a disc Basic playback controlsErasing the programme Different play modes Shuffle and RepeatProgramming track numbers Reviewing the programmeProgramming radio stations Tuning to radio stationsTuning to preset radio stations Radio ReceptionTo select and record a particular passage within a CD track Tape Operation / RecordingTape playback General information on recording Synchro start CD recordingListening to an external source Other ConnectionRecording from the radio System will not play or support the following Using USB connectivityUSB Connection Supported formats Information Regarding USB Direct Activating and deactivating Clock/TimerSetting the clock Setting the timerMaintenance SpecificationsCheck the speaker connections and location TroubleshootingTime is not working Remote control does not functionClock/Timer setting is erased ProperlyMeet Philips at the Internet Français