Philips MCM204 user manual Specifications, Maintenance

Page 22

Specifications

English

AMPLIFIER

 

Output power

2 x 4W RMS

Signal-to-noise ratio

60 dBA (IEC)

Frequency response

125 – 16000 Hz

Impedance loudspeakers

4

CD PLAYER

 

Frequency range

125 – 16000 Hz

Signal-to-noise ratio

65 dBA

TUNER

 

FM wave range

87.5 – 108 MHz

MW wave range

531 – 1602 kHz

Sensitivity at 75

 

– FM 26 dB sensitivity

20 µV

– MW 26 dB sensitivity

5 mV/m

Total harmonic distortion

5%

TAPE DECK

 

Frequency response

 

Normal tape (type I)

125 – 8000 Hz (8 dB)

Signal-to-noise ratio

 

Normal tape (type I)

40 dBA

Wow and flutter

0.4% JIS

SPEAKERS Bass reflex system

Dimensions (w x h x d) . 146 x 228 x 160 (mm)

GENERAL INFORMATION

AC Power

220 – 230 V / 50 Hz

Dimensions (w x h x d) ...

146 x 228 x 216(mm)

Weight (with/without speakers)

...............................................................

approx. 4.4 / 2.0 kg

Power consumption

 

Active

30 W

Standby

< 5 W

Eco Power Standby

< 1 W

Specifications and external appearance are subject to change without notice.

Maintenance

Cleaning the Cabinet

Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives.

Cleaning Discs

When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out.

Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records.

Cleaning the disc lens

After prolonged use, dirt or dust may accumulate at the disc lens.To ensure good playback quality, clean the disc lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner.

Cleaning the Heads and the Tape Paths

To ensure good recording and playback quality, clean the heads A, the capstan(s) B, and pressure roller(s) C after every 50 hours of tape operation.

Use a cotton swab slightly moistened with cleaning fluid or alcohol.

You can also clean the heads by playing a cleaning tape once.

A A B C

Demagnetising the heads

Use a demagnetising tape available at your dealer.

22

Image 22
Contents Micro Hi-Fi System MCM204Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KPage Klass 1 laseraparat 139 101120 158Contents General Information Supplied accessoriesSafety Information Environmental InformationTo establish a safe volume level Hearing SafetyListen at a moderate volume Set your volume control at a low settingRear connections PowerPreparations MW AntennaFM Antenna Before using the remote controlReplacing battery lithium CR2025 into the remote control Speakers Connection Front SpeakersControls on the system and remote control Controls available on the remote control onlyPower-saving automatic standby Switching the system onBasic Functions Adjusting volume and sound Basic playback controls CD/MP3 OperationLoading a disc Playing an MP3 discReviewing the programme Different play modes Shuffle and RepeatProgramming track numbers Erasing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Programming radio stationsGeneral information on recording Synchro start CD recording Tape Operation / RecordingTape playback To select and record a particular passage within a CD trackRecording from the radio Other ConnectionListening to an external source Supported formats Using USB connectivityUSB Connection System will not play or support the followingInformation Regarding USB Direct Setting the timer Clock/TimerSetting the clock Activating and deactivatingSpecifications MaintenanceTroubleshooting Check the speaker connections and locationProperly Remote control does not functionClock/Timer setting is erased Time is not workingFrançais Meet Philips at the Internet