Sharp LED TV Preparation, Attaching the Stand, Stand Unit Assembly, Building the Work Table

Preparation

Attaching the Stand

•Before attaching (or detaching) the stand, unplug the AC cord.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

•After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.

•Do not remove the stand from the TV unless using a wall mount bracket to mount it.

Before attaching the stand to the TV, build a work table on which to rest the TV.

• To build the table, use the cushioning materials used in the packaging.

TOP-L

TOP-R

TOP-C

•Of the cushioning materials used, TOP-C is also used during stand unit assembly. Be sure to assemble the stand unit before building the work table.

■Stand Unit Assembly

1Confirm that there are 12 screws (8 long screws and 4 short screws) supplied with the stand unit.

21 Set the post for the stand unit onto the TOP-C. 2 Attach the base to the post.

3Insert and tighten the 8 screws into the 8 holes on the bottom of the base.

•Hold the stand unit securely with one hand, and then tighten the screws.

3

Long screws

2

1 1

FRONT

■Building the Work Table

3Attach the joints and close the case.

1 Insert a joint into the hole on the side of the case. 2 Pressing the tab, fi x the joint into place.

1

2

5The case is equipped with push-in tabs to hold the cushioning materials in place. Push in the tabs (2 for each location) to secure the cushioning

materials in the case.

Push-in tabs

6After you have built the work table, spread a blanket or similar soft cloth over the table and then lay the TV display down on the covered table.

•Do not use a small table for this.

■Attaching the Stand to the TV

7Insert the stand into the openings on the bottom of the TV.

•Make sure that the stand is fi rmly inserted into the TV. Improper installation may result in tilting of the TV set.

8Insert and tighten the 4 screws into the 4 holes on the rear of the TV.

Short screws

4Insert each of the cushioning materials in the respective directions shown in the figure.

•Insert TOP-L and TOP-R into the left and right sides of the case respectively.

•Insert TOP-C to fit between the lines on the other side of the case.

TOP-L

CASE TOP-R

LINE

JOINT

TOP-C

NOTE

•In the installation procedure, be careful not to catch your fingers between the TV set and the floor.

8