FUNCTIONS | NAMES AND |
CONNECTIONS | BASIC |
OPERATION | BASIC |
CONNECTIONS | ADVANCED |
SETUP | |
OPERATION | ADVANCED |
TROUBLESHOOTING | |
OTHERS | |
ENGLISH
ADVANCED CONNECTIONS
CONNECTING THE REMOTE CONTROL JACKS
|
|
| 2 |
|
|
| Option |
|
|
|
|
|
|
| |
|
|
|
|
| RC OUT |
|
|
MONITOR OUT | OUT | DVD | MONITOR OUT |
|
|
|
|
|
|
| GAME | DVD | DSS | OUT |
FM |
|
|
|
|
|
| 3 |
|
IN | IN | IN | Y | PB/CB PR/CR | Y | PB/CB PR/CR |
| |
(75Ω) | DVD | DSS | VCR |
| DSS |
| VCR |
|
|
| VIDEO |
|
| COMPONENT VIDEO |
| MODEL NO. NR1501 | |
|
|
|
|
|
|
|
| |
GND | L |
|
|
|
| PRE OUT | 2 | AC IN |
|
|
|
|
|
| |||
AM
R |
|
|
|
|
|
|
|
| 1 |
|
|
|
|
IN | IN | IN | OUT | IN | IN | SUB |
|
| R - FRONT - L | CENTER | R - SURR. - L | R | L |
IN | OUT | IN |
|
| SURROUND BACK | ||||||||
DVD | DSS |
| VCR | CD | AUX 2 | WOOFER | DIGITAL |
|
| ||||
ANTENNA |
| ANALOG AUDIO |
|
|
| REMOTE CONTROL | AUDIO | SPEAKER SYSTEMS : |
|
| |||
1
REMOTE | CD recorder | REMOTE | DVD player | REMOTE | CD player |
CONTROL |
| CONTROL |
| CONTROL |
|
IN |
| IN |
| IN |
|
OUT |
| OUT |
| OUT |
|
| EXTERNAL INTERNAL |
| EXTERNAL INTERNAL |
| EXTERNAL INTERNAL |
q
You can control other Marantz products through this unit with the remote controller by connecting the REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller is received by the remote sensor on this unit. Then the signal is sent to the connected device through this terminal. Therefore you need to aim the remote control only at the unit. Also, if a Marantz power amplifier (some models excluded) is connected to one of these terminals, the power amplifier’s, power switch is synchronized with this unit’s power switch.
Set the REMOTE CONTROL SWITCH on the back of other units (not the NR1501) to “EXT.” (EXTERNAL) to use this feature.
w
Whenever external infrared sensors or similar devices are connected to
1. Hold down the 3 cursor button and the MENU button on the front panel at the same time for five seconds.
2. The setting “ENABLE” is shown on the FL DISPLAY.
3. Press the CURSOR buttons (1, 2) to change this to “DISABLE”.
4. Press the ENTER button. Once this setting is made, the infrared sensor on the unit is disabled.
Note
•Be sure to set to “ENABLE” when external infrared sensors or similar devices are not connected. Otherwise, the unit will be unable to receive remote control commands.
5. To restore the original setting, perform steps 1 to 4 to set to “ENABLE”.
16