ENGLISH
NAMESAND FUNCTIONS | ADVANCED OPERATION | |
(PRESET MEMORY) | ||
| TUNER OPERATIONS | |
BASIC CONNECTIONS | With this unit, up to 30 FM and AM broadcast | |
stations can be preset in the sequence desired. | ||
| ||
| For each of these stations, the frequency and | |
| reception mode can be stored in the memory as | |
| needed. | |
| AUTO PRESET MEMORY | |
BASIC OPERATION | This function makes it possible to scan the FM band | |
automatically and store all stations with suitable | ||
| ||
| signal strength in the unit's preset memories. | |
ADVANCED CONNECTIONS | 1. 2. | |
1. | ||
| 2. | |
SETUP | 1. Hold down the unit's MEMORY button | |
or the EXIT/MEMO button on the remote | ||
controller for at least two seconds. | ||
| “AUTO MEM” appears on the display, and | |
| scanning starts from the lowest frequency. | |
ADVANCED OPERATION | 2. Scanning automatically stops when all 30 | |
preset memories have been set or when | ||
| ||
| auto scanning has reached the uppermost | |
| limit of the band. | |
| To stop the auto preset memory operation | |
| at any time, press the unit's MEMORY | |
TROUBLESHOOTING | button or the EXIT/MEMO button on the | |
remote controller. | ||
| ||
| Note | |
| The auto preset cannot be performed for AM | |
| stations. Perform the manual preset instead. | |
OTHERS |
|
30
MANUAL PRESET MEMORY
(When performing the operations using the unit's controls)
3.2. 4.
1. Tune into the frequency of the broadcast station to be set.
(Refer to the section on “MANUAL TUNING” or “AUTO TUNING”.)
2. Press the unit’s MEMORY button. The MEM indicator starts blinking on the display.
3. While the MEM indicator is still blinking, press the 1/2 cursor buttons to select the preset number.
4. Press the MEMORY button again to enter the selection.
The indicator stops blinking, and the broadcast station is stored in the preset memory selected.
(When performing the operations using the remote controller)
3.
2. 
4.
1. Tune into the frequency of the broadcast station to be set.
(Refer to the section on “MANUAL TUNING” or “AUTO TUNING”.)
2. Press the EXIT/MEMO button on the remote controller. The MEM indicator starts blinking on the display.
3. While the MEM indicator is still blinking, press the 1/2 cursor buttons to select the preset number.
4. Press the EXIT/MEMO button again to enter the selection.
CALLING PRESET STATIONS
1.
1.
2.
2.
(When performing the operations using the unit's controls)
1. Press the unit’s 1/2 cursor buttons to select the preset station to be called.
(When performing the operations using the remote controller)
1. Press the TUNE button on the remote controller twice in succession.
2. Press the 1/2 cursor buttons to select the preset station whose programs are to be heard.
Alternatively, press the numeric buttons to select the preset station.