Panasonic CQ-5335U Radio Preset Station Setting, Auto Preset Memory APM, Manual Preset Memory

Page 10

Radio (Continued)

Preset Station Setting

Up to 6 stations can be saved in each of the FM1, FM2 and AM preset station memories.

Note: Existing saved stations are overwritten with new stations after following this procedure.

qBand

Press [BAND] to select a desired band. (➡ page 9)

CLK

PWR

ALM
PUSH SEL/SAT	DISP	CQ-5335U					LOUD
VOL
	MODE						MUTE
							TUNE
		DISC		CD SCAN	RPT	RDM	SEEK
	BAND	DISC		CD SCAN	RPT	RDM	SCAN
	BAND						SCAN
BASS/TREB/BAL/FADER	1	2	3	4	5	6	ILL
BASS/TREB/BAL/FADER	APM						ILL

Preset buttons from [1] to [6]

w Auto Preset Memory (APM)

Press and hold [BAND] (APM: auto preset memory) for more than 2 seconds.

•The 6 stations with good reception will be automatically saved in the memory under preset buttons from [1] to [6].

•Once set, the preset stations are sequentially scanned for 5 seconds each.

•Press [BAND] again to stop sequentially scan.

Manual Preset Memory

q Use manual or seek tuning to find a station. (➡ page 9)

w Press and hold one of the preset buttons from [1] to [6]

until the display blinks once.	blinks once

Preset Station Calling	Caution: To ensure safety, never attempt to preset stations
Press the corresponding preset button from [1]	while you are driving.
to [6] to tune in a preset station.

10

CQ-5335U

Image 10

Contents CQ-5335U Laser Products Wave length 780 nm Safety InformationFollowing applies only in the U.S.A FCC WarningUse Authorized Service centers When DrivingWhen Washing Your Car When ParkedContents Volume Power and Sound ControlsPower LoudnessTreble Illumination SwitchingBass BalanceSelecting the Clock Display Clock SettingTime Reset Initial TimeAlarm Operation Alarm Time SettingInitial Alarm Time Alarm output Volume SelectionRadio Manual Preset Memory Radio Preset Station SettingAuto Preset Memory APM Preset Station CallingTuning in a Weather Band Station Weather Band StationsStop and Disc Eject CD PlayerDisc Insert and Playback Disc insert Listening to a CDTrack Selection Track Search Repeat play Random play Scan playDisc Selection CD Changer modeCD Changer Control Track SelectionRepeat Play Tracks Discs Remote ControlScan Play Tracks Discs Random Play Tracks DiscsPreliminary Steps TroubleshootingCommon Radio Select other stations of higher signal levelClean disc, referring to the section on Notes on Discs Extend fully the radio antennaConnect the speaker wires to the correct ones Sound SettingAdjust mounting angle to less than 30˚ Trouble Sound skips due to vibration Disc is not ejectedCheck the disc Error Display MessagesCD changer Select the next available compact disc. Check the discCleaning this Unit MaintenanceCare of the Unit Wrong Speaker ConnectionsProduct Servicing ChassisPanasonic Servicenter List for Service Directory Installation GuideDashboard Specifications OverviewInstallation Hardware InstallationDashboard Installation Using the rubber cushion optionMounting springs C ExampleTo Remove the Unit from the vehicles dashboard Insert each Removal Tool i and pull Removal Tool U-shapedElectrical Connections Wiring DiagramCD Receiver Not used Specifications Memo Memo