Panasonic CQ-5335U operating instructions Radio, Select other stations of higher signal level

Page 17

Troubleshooting (Continued)

❐Radio

Trouble

Much noise in FM stereo and monaural broad- casts.

Preset station is reset.

Cause/Step

Station is too far, or signals are too weak.

a Select other stations of higher signal level.

The radio antenna is not extended enough.

a Extend fully the radio antenna.

Battery cable is not correctly connected.

a Connect the battery cable to the terminal that is always active.

❐CD

Trouble

Disc is in the CD compartment but no sound is made, or disc is ejected automatically.

Sound skips, bad sound quality. (e.g. caused by noise)

Cause/Step

Disc is upside down.

a Place disc in the correct direction with the label side up.

•Disc is dirty.

•Disc has scratches.

a Clean disc, referring to the section on “Notes on Discs”.

A disc that has data other than CD-DA type is loaded. a Discs that have CD-DA type data should be used.

a The unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

•Disc is dirty.

•Disc has scratches.

a Clean disc, referring to the section on “Notes on Discs”.

a The unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details.

17

CQ-5335U

Image 17

Contents CQ-5335U Following applies only in the U.S.A Safety InformationLaser Products Wave length 780 nm FCC WarningWhen Washing Your Car When DrivingUse Authorized Service centers When ParkedContents Power Power and Sound ControlsVolume LoudnessBass Illumination SwitchingTreble BalanceTime Reset Clock SettingSelecting the Clock Display Initial TimeInitial Alarm Time Alarm Time SettingAlarm Operation Alarm output Volume SelectionRadio Auto Preset Memory APM Radio Preset Station SettingManual Preset Memory Preset Station CallingWeather Band Stations Tuning in a Weather Band StationDisc Insert and Playback Disc insert CD PlayerStop and Disc Eject Listening to a CDRepeat play Random play Scan play Track Selection Track SearchCD Changer Control CD Changer modeDisc Selection Track SelectionScan Play Tracks Discs Remote ControlRepeat Play Tracks Discs Random Play Tracks DiscsCommon TroubleshootingPreliminary Steps Clean disc, referring to the section on Notes on Discs Select other stations of higher signal levelRadio Extend fully the radio antennaAdjust mounting angle to less than 30˚ Sound SettingConnect the speaker wires to the correct ones Trouble Sound skips due to vibration Disc is not ejectedCD changer Error Display MessagesCheck the disc Select the next available compact disc. Check the discCare of the Unit MaintenanceCleaning this Unit Product Servicing Speaker ConnectionsWrong ChassisDashboard Specifications Installation GuidePanasonic Servicenter List for Service Directory OverviewDashboard Installation InstallationInstallation Hardware Using the rubber cushion optionExample Mounting springs CInsert each Removal Tool i and pull Removal Tool U-shaped To Remove the Unit from the vehicles dashboardCD Receiver Wiring DiagramElectrical Connections Not used Specifications Memo Memo