Panasonic CQ-5335U operating instructions Power and Sound Controls, Volume, Loudness, Mute

Page 5

Power and Sound Controls

Power

Turn the key in the ignition until the accessory indicator lights.

Power on: Press [PWR] (power).

Power off: Press [PWR] (power) again.

ACC

Remote Control Signal Sensor

Point the remote control unit (CA-RC 500U, option) toward the unit's sensor.

CLK

PWR

ALM
PUSH SEL/SAT	DISP	CQ-5335U				LOUD
VOL
	MODE					MUTE
	BAND	DISC		CD SCAN	RPT	RDM
	BAND					SCAN
	1	2	3	4	5	6
BASS/TREB/BAL/FADER	APM					ILL

TUNE SEEK

Volume

Turn the knob clockwise to increase volume, and counterclockwise to decrease volume.

Volume level (0 to 40)

(default:18)

Down

Loudness

Press and hold [MUTE] (LOUD) for more than 2 seconds to enhance bass and treble tones when listening at low or medium volume.

Press and hold [MUTE] (LOUD) for more than 2 seconds again to deactivate when listening at higher volumes.

Mute

Press [MUTE] to mute the sound completely.

Press [MUTE] again to cancel.

CQ-5335U

Image 5

Contents CQ-5335U Following applies only in the U.S.A Safety InformationLaser Products Wave length 780 nm FCC WarningWhen Washing Your Car When DrivingUse Authorized Service centers When ParkedContents Power Power and Sound ControlsVolume LoudnessBass Illumination SwitchingTreble BalanceTime Reset Clock SettingSelecting the Clock Display Initial TimeInitial Alarm Time Alarm Time SettingAlarm Operation Alarm output Volume SelectionRadio Auto Preset Memory APM Radio Preset Station SettingManual Preset Memory Preset Station CallingWeather Band Stations Tuning in a Weather Band StationDisc Insert and Playback Disc insert CD PlayerStop and Disc Eject Listening to a CDRepeat play Random play Scan play Track Selection Track SearchCD Changer Control CD Changer modeDisc Selection Track SelectionScan Play Tracks Discs Remote ControlRepeat Play Tracks Discs Random Play Tracks DiscsCommon TroubleshootingPreliminary Steps Clean disc, referring to the section on Notes on Discs Select other stations of higher signal levelRadio Extend fully the radio antennaAdjust mounting angle to less than 30˚ Sound SettingConnect the speaker wires to the correct ones Trouble Sound skips due to vibration Disc is not ejectedCD changer Error Display MessagesCheck the disc Select the next available compact disc. Check the discCare of the Unit MaintenanceCleaning this Unit Product Servicing Speaker ConnectionsWrong ChassisDashboard Specifications Installation GuidePanasonic Servicenter List for Service Directory OverviewDashboard Installation InstallationInstallation Hardware Using the rubber cushion optionExample Mounting springs CInsert each Removal Tool i and pull Removal Tool U-shaped To Remove the Unit from the vehicles dashboardCD Receiver Wiring DiagramElectrical Connections Not used Specifications Memo Memo