Panasonic CQ-5335U Sound Setting, Trouble Sound skips due to vibration Disc is not ejected

Page 18

CD (Continued)

Trouble

Sound skips due to vibration.

Disc is not ejected.

Time is counted but no sound comes out.

Sound Setting

Trouble

No sound from left, right, front, or rear speaker.

Left and right sounds are reversed in stereo listening.

18

Cause/Step

Mounting angle is over 30˚.

a Adjust mounting angle to less than 30˚.

Instable mounting.

a Mount the unit securely with the mounting parts, referring to the section on installation.

Disc is defective.

Mechanical trouble.

a Press [u] (eject). If normal operation is not restored, call the store where you purchased the unit or the nearest Service center to ask for repairs.

The first track of a mix mode disc was reproduced. (Mix mode is a format in which data except music is recorded on the first track and music data is recorded on other than the first track in a session.)

a Playback music data recorded on other than the first track.

Cause/Step

Left and right balance, or front and rear balance is off on one side. a Adjust BAL/FAD as appropriate.

Cables are not correctly connected.

a Connect the cables correctly.

The right speaker wire is connected to the left speaker and the left speaker wire to the right speaker.

a Connect the speaker wires to the correct ones.

CQ-5335U

Image 18
Contents CQ-5335U Laser Products Wave length 780 nm Safety InformationFollowing applies only in the U.S.A FCC WarningUse Authorized Service centers When DrivingWhen Washing Your Car When ParkedContents Volume Power and Sound ControlsPower LoudnessTreble Illumination SwitchingBass BalanceSelecting the Clock Display Clock SettingTime Reset Initial TimeAlarm Operation Alarm Time SettingInitial Alarm Time Alarm output Volume SelectionRadio Manual Preset Memory Radio Preset Station SettingAuto Preset Memory APM Preset Station CallingTuning in a Weather Band Station Weather Band StationsStop and Disc Eject CD PlayerDisc Insert and Playback Disc insert Listening to a CDTrack Selection Track Search Repeat play Random play Scan playDisc Selection CD Changer modeCD Changer Control Track SelectionRepeat Play Tracks Discs Remote ControlScan Play Tracks Discs Random Play Tracks DiscsTroubleshooting Preliminary StepsCommon Radio Select other stations of higher signal levelClean disc, referring to the section on Notes on Discs Extend fully the radio antennaConnect the speaker wires to the correct ones Sound SettingAdjust mounting angle to less than 30˚ Trouble Sound skips due to vibration Disc is not ejectedCheck the disc Error Display MessagesCD changer Select the next available compact disc. Check the discMaintenance Cleaning this UnitCare of the Unit Wrong Speaker ConnectionsProduct Servicing ChassisPanasonic Servicenter List for Service Directory Installation GuideDashboard Specifications OverviewInstallation Hardware InstallationDashboard Installation Using the rubber cushion optionMounting springs C ExampleTo Remove the Unit from the vehicles dashboard Insert each Removal Tool i and pull Removal Tool U-shapedWiring Diagram Electrical ConnectionsCD Receiver Not used Specifications Memo Memo