Mitsubishi Electronics MDT651S manual 11Remote control, LAN Remote control

U-11Remote control (continued)

Carry out as necessary

5)Read command

The computer sends the command without datacode to the monitor.

After receiving this command, the monitor returns the command with datacode including the current status to the computer. Example: When the computer asks the power status of the monitor, and the status of the monitor is powered-on.

Command from computer				Command from monitor				Detail of command
30 30 76 50 0D	‘0’‘0’‘v’‘P’[enter]						Ask about the power status of the monitor.
			30 30 76 50 31 0D		‘0’‘0’‘v’‘P’‘1’[enter]		Monitor is powered-on.
Structure of the Read-command
					ASCII			HEX
				Function		Data (Receive)	Function		Data (Receive)
POWER	ON			vP		1	76 50		31
	OFF (stand by)			vP		0	76 50		30
	RGB-1 (HDMI)			vI		r1	76 49		72 31
	RGB-2 (DVI-D)			vI		r2	76 49		72 32
	RGB-3 (D-SUB)			vI		r3	76 49		72 33
	RGB-4 (BNC)			vI		r4	76 49		72 34
Input	RGB-5 (CAT5)			vI		r5	76 49		72 35
	RGB-6 (DISPLAY PORT)			vI		r6	76 49		72 36
	Video			vI		v1	76 49		76 31
	DVD/HD			vI		v2	76 49		76 32
	S-VIDEO			vI		v3	76 49		76 33
	Around the main	Resolution		tc1		(ex.) +25	74 63 31		2B 20 32 35
Internal	board	1˚C
temperature	Around the power	Resolution		tc2		(ex.) +31	74 63 32		2B 20 33 31
	supply	1˚C

LAN Remote control

By connecting the monitor and the computer using a network device such as a LAN hub as shown in Section P-7 and making the network settings using the OSD menu and RS-232C communication control, you can perform remote control using the same commands as those for RS-232C.

1.Setting procedure

(1)Set the following network parameters using the OSD menu. (See page 47.)

• ON/OFF, IP address, subnet mask, gateway mask setting, and default gateway of DHCP client

(2)Send the same control command as that for RS-232C via TCP/IP socket communication.

(3)Check the status sent from the monitor. When it is received successfully, the setting is completed.

Downloaded From TV-Manual.com Manuals English-38