Mitsubishi Electronics MDT651S manual CONFIGURATION2

OSD screen functions (continued)

CONFIGURATION2

English

￿CAT5 CONTROL

[CAT5 CABLE LENGTH]

Select the cable length, and the defaults of all the adjustment values are automatically determined.

Select the length that is closest to the actual length of your cable.

[CAT5 EQ.]

Make adjustment so that blur and smear of the displayed letters and graphic objects are minimized.

[CAT5 RED GAIN, GREEN GAIN, BLUE GAIN]

When the displayed image is dark, increase each value. When whites aren’t displayed as intended, adjust the RED GAIN and BLUE GAIN values.

NOTE: Before performing the color adjustment described above, check the TINT settings on page 41.

[CAT5 RED SKEW, GREEN SKEW, BLUE SKEW]

￿MONITOR ID

ID numbers for wireless remote control are assigned to MDT651S monitors that are multi-connected via RS-232C. ID numbers 1 to 26 are selectable.

￿OSD TURN OFF

The OSD control menu will stay on as long as it is used. The preset choices are 5 -120 seconds.

￿OSD H POSITION

You can adjust the horizontal position of the OSD menu.

￿OSD V POSITION

You can adjust the vertical position of the OSD menu.

￿OSD ROTATION

The OSD screen is rotated.

OFF H FLIP V FLIP

Adjust each value so that the color deviation in the displayed letters and graphic objects is minimized.

￿SERIAL CONTROL

Select the communication interface (RS-232C or LAN) for the serial communication function.

For connection of the signal cable, see page 36.

￿RS485 TERMINATION

Turn ON or OFF the termination resistance of the RS-485 interface.

ON: Select this setting to use the monitor alone or to configure the monitor as the one at the end of the connection when more than one monitor is multi- connected.

OFF: Select this setting to configure the monitor as other than the one at the end of the connection when more than one monitor is multi-connected.

￿LAN SETTING DHCP CLIENT

Select whether to use DHCP client or not.

Select OFF when not using it, and select ON when using it.

IP ADDRESS

Set the IP address of the monitor.

SUBNET MASK

Set the gateway mask.

Set it to 255.255.255.0 for normal use.

DEFAULT GATEWAY

Set the IP address of the gateway router to externally connect the local area including the monitor.

RESET

LAN settings are reset.

Horizontally Vertically

rotated rotated

￿INFORMATION OSD

You can enable and disable the information OSD display. The display time is selectable from 3 to 10 seconds. NOTE: The information OSD display shows a message

when the input source is switched, the input signal state is changed, or the input signal has an error.

￿OFF TIMER

You can select the OFF TIMER mode.

Select the time period to automatically turn off the power from 1 to 24 hours.

NOTE: When OFF TIMER is enabled, the SCHEDULE settings (see page 48) will be disabled.

Downloaded From TV-Manual.com Manuals English-47