Attaching Mounting Accessories, Stand Removal, English-10

Attaching Mounting Accessories

The display is designed for use with the VESA mounting system.

1. Attach Mounting Accessories

Mounting accessories can be attached while the monitor is on the Tabletop Stand in the upright position (Figure 1). Be careful to avoid tipping monitor when attaching accessories. After accessories are attached, stand can be removed (Figure 3).

VESA Mounting Interface

Tabletop Stand

Figure 1

Mounting accessories can be attached with the monitor in the face down position. To avoid damaging the screen face, place the protective sheet on the table underneath the LCD. The protective sheet was wrapped around the LCD in the original packaging. Make sure there is nothing on the table that can damage the monitor.

When using mounting accessories other than NEC compliant and approved, they must comply with the VESA- compatible mounting method. NEC strongly recommends using screws M6 size and 10mm in length. If using screws longer than 10mm, check the depth of the hole. (Recommended Fasten Force: 470-635N¥cm)

NEC recommends using mounting interface that comply with UL1678 standard in North America.

This device cannot be used or installed without the Tabletop Stand or other mounting accessory for support. For proper installation it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding the warranty.

Protective Sheet

Table

Tabletop Stand

Figure 2

2. Stand Removal

To detach stand, place the monitor face down as shown in Figure 2. Remove the screws from the back of the stand as indicated in Figure 3. Remove the 2 additional screws located at the bottom of the stand (Figure 4). Lift up stand to remove after stand is removed, replace the screws into the original holes.

Circles indicate screw locations (8 screws)

Figure 3

2 screws under stand

Figure 4

To re-attach the stand. Place the monitor face down on the protective sheet to prevent damage. Remove the screws from their holes as indicated in Figure 3. Slide the stand into place, making sure that the inside tabs located on the left and right of the stand are placed into the corresponding slots on the display (Figure 5).

Figure 5

The bottom of the stand should fit underneath the monitor. Use the screws to secure the stand to the monitor.

NOTE: When removing stand, be sure to remove the 2 screws on the bottom of the stand (Figure 4). Not removing these screws will result in damage to the monitor.