Setup
1. Determine the installation location
CAUTION: Installing your LCD display must be done by a qualified technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE. Failure to follow this caution may result in injury if the LCD monitor falls.
CAUTION: Do not mount or operate the display upside down, face up, or face down.
CAUTION: This LCD has a temperature sensor and cooling fan. If the LCD becomes too hot, the cooling fan will turn on automatically. If the LCD becomes overheated while the cooling fan is running, the ÒCautionÓ menu will appear. If the ÒCautionÓ menu appears, discontinue use and allow the unit to cool. Using the cooling fan will reduce the likelihood of early circuit failure and may help reduce image degradation and ÒImage PersistanceÓ.
If the LCD is used in an enclosed area or if the LCD panel is covered with a protective screen, please check the inside temperature of the monitor by using the ÒHEAT STATUSÓ control in the OSM (see page 27). If the temperature is higher than the normal operating temperature, please turn the cooling fan to ON within the FAN CONTROL menu within the OSM (see page 27).
IMPORTANT: Lay the protective sheet, which was wrapped around the LCD monitor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by two 1.5V AA batteries. To install or replace batteries:
A.Press and slide to open the cover.
B.Align the batteries according to the (+) and (Ð) indications inside the case.
C.Replace the cover.
CAUTION: Incorrect usage of batteries can result in leaks or bursting.
NEC recommends the following battery use:
¥Place ÒAAÓ size batteries matching the (+) and
¥Do not mix battery brands.
¥Do not combine new and old batteries. This can shorten battery life or cause liquid leakage of batteries.
¥Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
¥Do not touch exposed battery acid, it may injure skin.
NOTE: If you do not intend to use the Remote Control for a long period of time, remove the batteries.
3. Connect external equipment (See pages 14-20)
¥To protect the external equipment; turn off the main power before making connections.
¥Refer to your equipment user manual for further information.
4. Connect the supplied power cord
¥The equipment should be installed close to an easily accessible power outlet.
¥Please attach power cord to the LCD monitor by attaching the screw and clamp.
¥Fully insert the prongs into the power outlet socket. A loose connection may cause image degradation.
NOTE: Please refer to ÒSafety Precautions and MaintenanceÓ section of this manual for proper selection of AC power cord.
Screw
Clamp
Screw hole for clamp 