Installation
DIN Front-mount
Installation with the rubber bush
Dashboard
182
53
Removing the unit
Holder
After inserting the holder into the
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.)
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
En
English
Español
Deutsch Français Italiano
Nederlands
13