Pioneer DVH-P5050MP installation manual No ACC position

Connecting the Units

•Speakers connected to this unit must be high- power types with minimum rating of 50 W and impedance of 4 to 8 ohms. Connecting speak- ers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged.

•If the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector.

•When this product’s source is switched ON, a control signal is output through the blue/white lead. Connect to an external power amp’s system remote control or the car’s Auto-antenna relay control terminal (max. 300 mA 12 V DC). If the car features a glass antenna, connect to the antenna booster power supply terminal.

•When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp’s power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna.

Such connection could cause excessive cur- rent drain and malfunction.

•To avoid short-circuiting, cover the discon- nected lead with insulating tape. Especially, insulate the unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not insulated.

•To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. Connect the connectors of the same colors correctly.

•If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with igni- tion switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for sev- eral hours.

		CC
	F	A	O				F	O
			N					N
O	F					O	F
					S					S
					T					T
				R	A				R	A
			T					T
ACC position						No ACC position

•The black lead is ground. Please ground this lead separately from the ground of high-cur- rent products such as power amps.

If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire.

•Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both prod- ucts and connect cords that have the same

function.

English

Español

Deutsch Français Italiano

Nederlands

En 3