DIN Front-mount
Installation with the rubber bush
1.Decide the position of the side brackets. (Fig. 13)
When installing in a shallow space, change the position of side brackets. In this case, stick conceal tape on parts that protrude from the dashboard.
Conceal tape
Side bracket
Flush surface screw (5 ⋅ 6 mm)
Fig. 13
2.Install the unit into the dash- board. (Fig. 14)
After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Dashboard
182
53 | Rubber bush |
| |
| Screw |
Holder
Side bracket
Screw (2 ⋅ 3 mm)
•After installing the unit into the dashboard, reattach the frame.
Fig. 14
English
Español
Português (B) Français Italiano
Nederlands
14