Pioneer AVH-P7550DVD installation manual Connecting the Units, Contents

Page 2

Contents

 

Connecting the Units

 

 

 

Connecting the Units

1

Connecting the system

3

Connecting the power cord (1)

4

Connecting the power cord (2)

5

When connecting to separately sold power

 

amp

7

When connecting with a back-up camera

9

When connecting the external video

 

component and the display

10

Attaching the noise filters

11

Installation

12

Installing the hide-away unit

13

DIN Front/Rear-mount

13

DIN Front-mount

14

DIN Rear-mount

15

Installing the remote control unit

15

CAUTION:

PIONEER does not recommend that you install or service your display your- self. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to autho- rized Pioneer service personnel.

Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.

Do not drill a hole into the engine com- partment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insu- lation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point.

It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving.

Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat slid- ing mechanism.

Do not shorten any leads. If you do, the protection circuit may fail to work properly.

1

Image 2
Contents Installation Manual Connecting the Units ContentsEspañol Português B Français Italiano Nederlands Connecting the system Connecting the power cord Left Português B Français Italiano Nederlands When connecting to separately sold power amp Front OutputEspañol Português B Français Italiano When connecting with a back-up camera When connecting the external video component and the display When using a display connected to rear video outputAttaching the noise filters Installation DIN Front/Rear-mount Installing the hide-away unitBefore installing the unit Mounting with BracketsInstallation with the rubber bush DIN Front-mountInstallation using the screw holes on the side of the unit DIN Rear-mountInstalling the remote control unit Conexión de las unidades ContenidoEnglish Conexión al sistema Conexión del cable de alimentación Unidad oculta-alejada Portafusible AmarilloIzquierda Deutsch Français Italiano Este producto Italiano Cuando conecte con una cámara de vista trasera Cuando conecte el componente externo y la pantalla AdvertenciaInstalación de filtros de ruido Instalación Montaje con ménsulas Instalación de la unidad oculta- alejadaMontaje trasero/delantero DIN Montaje con cinta adherenteMontaje delantero DIN Instalación con tope de gomaMontaje trasero DIN Instalação do controle remoto Conexão das unidades SumárioEnglish Español Português B Français Italiano Nederlands Conexão do sistema Conexão do cabo de alimentação Esquerda Nota Saída central Esquerda Direita Quando conectar com uma câmera de marcha-ré Quando conectar um componente de vídeo externo e um monitor AdvertênciaInstalação de filtros de ruído Instalação Montagem com suportes Instalação da unidade ocultaMontagem dianteira/traseira DIN Montagem com fita velcroMontagem dianteira DIN Instalação com uma bucha de bor rachaMontagem traseira DIN Instalação do controle remoto Page Page Pioneer Corporation