Installation
Installing the hide-away unit
Mounting with Brackets
Tapping screw (4 ⋅ 12 mm)
Screw
(4 ⋅ 8 mm)
Car mat or chassis | Bracket |
|
Drill 2 to 2.5 mm diameter holes.
Fig. 10
Mounting with Velcro Tape
Thoroughly wipe off the surface before affixing the velcro tape.
Velcro tape (large)
Car mat or chassis
Fig. 11
DIN Front/Rear-mount
This unit can be properly installed either from “Front” (conventional DIN
Before installing the unit
•Remove the frame and the hold- er. (Fig. 12)
Pull out to remove the frame and then loosen the screws (2 ⋅ 3 mm) to remove the holder. (When reattaching the frame, point the side with a groove downwards and attach it.)
Holder
Screw (2 ⋅ 3 mm)
Frame
Fig. 12
13