SLEEVE AND MANIFOLD INSTALLATION
METHOD FOR STANDARD WALLS
1.
The flue consists of 3 parts, sleeve, inside |
|
|
|
connectors and tube, outside terminal; (dis- |
|
|
|
assemble by pulling hard on outside terminal |
|
|
|
and inner connections, then pull sleeve off outer |
|
|
|
terminal). | Connections | Sleeve | Terminal |
|
|
2. Adjustment of Sleeve Length. |
|
| |
Measure wall thickness through previously | Extension joint |
| |
drilled 80mm hole. | Extension | ||
under plastic | |||
End of sleeve should protrude |
|
| |
outside wall. Adjust sleeve length to wall |
| (‘A’ and ‘S’ flues only) | |
thickness plus | Adjust length by turning sleeve. | ||
adjustment). | |||
|
|
3. For A and S flues only |
|
|
| |
Depending on flue set and wall thickness | A | B | C | |
extension piece “C” may need to be removed. | ||||
|
|
| ||
Cut plastic, remove extension, then follow |
|
|
| |
instruction 2. |
|
|
| |
This applies to “A” and “S” flues only. |
|
| Remove extension at this | |
There is no extension on other flues, they can |
|
| ||
|
| point if necessary. | ||
be fully adjusted by turning the threaded |
|
|
| |
section. |
|
|
| |
|
|
|
| |
4. Fixing Sleeve. |
|
| ||
|
|
| ||
Fix to the wall, using the 3 screws provided. | "TOP" |
|
| |
|
|
| ||
NOTE: |
|
|
| |
The flange is marked “TOP”, sleeve must be |
|
|
| |
fitted with this mark UP. | Fixing Screw |
|
| |
Check sleeve protrudes |
|
|
| |
outside. | Don't remove green plastic covering from sleeve. | |||
|
– 29 –