Pioneer DEH-3100UB operation manual Setting the clock, Setting the AM tuning step

Black plate (25,1)

Initial Settings

Adjusting initial settings Setting the FM tuning step

Section

04

English

1Press SRC/OFF and hold until the unit turns off.

2Press MULTI-CONTROL and hold until CLOCK SET appears in the display.

3Turn MULTI-CONTROL to select one of the initial settings.

CLOCK SET (clock)—FM STEP (FM tuning step)—AM STEP (AM tuning step)—AUX (auxiliary input)—SW CONTROL (rear output and subwoofer controller)—EVER SCROLL

(ever scroll)

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

# To cancel initial settings, press BAND/ESC.

Setting the clock

Use these instructions to set the clock.

1Use MULTI-CONTROL to select CLOCK SET in the initial setting menu. Refer to Adjusting initial settings on this page.

2Press MULTI-CONTROL to display the

setting mode.

# Press DISP/BACK/SCRL to return to the pre-

The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz.

!If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again.

1Use MULTI-CONTROL to select FM STEP in the initial setting menu.

Refer to Adjusting initial settings on this page.

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the FM tuning step.

Turning MULTI-CONTROL will switch the FM tuning step between 50 kHz and 100 kHz. The selected FM tuning step will appear in the dis-

play.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

4Press MULTI-CONTROL to determine

the selection.

# Even if the menu has been cancelled before determination, operation is settled.

vious display.

3Press MULTI-CONTROL to select the seg- ment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute

As you select segments of the clock display, the selected segment blinks.

4Turn MULTI-CONTROL to put a clock

right.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Note

The tuning step remains at 50 kHz during manual tuning.

Setting the AM tuning step

The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable).

1Use MULTI-CONTROL to select AM STEP in the initial setting menu.

Refer to Adjusting initial settings on this page.

En 25

<YRD5269-A/S>25