Basic Operations
9 8 OPEN/CLOSE / -
RESET switch PWR | AUX |
Using Face Cover
An
Put the face cover onto the
Be sure to remove the
NOTES
•If the monitor touches an obstacle while it is being raised, the unit will stop raising the monitor immediately. Should this occur, remove the obstacle and press the OPEN/CLOSE button again to raise the monitor.
•When the movable monitor is opened, do not place any object on the monitor and be careful not to bump or apply any pressure to the monitor while it is open. This can cause damage to the mechanism.
•Under low ambient temperature conditions, the display may be dark for a short period of time immediately after the power is turned on. Once the LCD has warmed up, the display will return to normal.
•For your safety, some operation of the unit cannot be performed while the vehicle is in motion. In this case, first stop the vehicle and engage the parking brake, then perform the operation.
Initial System Start-up
Immediately after installing or applying power to the unit, it should be initialized.
1 At the lower left corner of the screen front panel, there is a small button. Using a pencil or other pointed object, press this RESET switch to complete the initialization procedure.
Raising the Monitor
NOTE
The
1 Press the OPEN/CLOSE button.
The unit beeps 3 times and raises the monitor automatically.
Lowering the Monitor
NOTE
The
1 Press the OPEN/CLOSE button.
The unit will beep 3 times and lower the monitor automatically.
NOTE
If the monitor touches an obstacle while it is being lowered, the unit will stop lowering the monitor immediately.
Should this occur, remove the obstacle and press the OPEN/CLOSE button again to lower the monitor.