Alpine TME-M790 owner manual Information, Case of Difficulty, Specifications

Page 15

Information

In Case of Difficulty

If you encounter a problem, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer.

No function or display.

Car's ignition is off.

-Turn the ignition on.

No fuse or blown fuse.

-Check the cause and replace the fuse.

Incorrect connections.

-Check connection and remedy.

Vehicle's battery is weak.

-Check the voltage of vehicle's battery.

Unclear picture display.

Fluorescent tube is exhausted. - Replace the fluorescent tube.*

No picture display.

Brightness control is set for minimum brightness control.

-Adjust the brightness.

Incorrect setting of the VCR mode.

-Switch to the correct mode.

Protective circuit is on because of high temperature.

-Wait until the temperature inside the vehicle comes down to the operating temperature range (45°C).

Incorrect or open connection with the Monitor, AV interface unit.

-Check the connection and remedy.

Picture color is poor.

Brightness/Color/Tint control are not set to the proper positions.

-Check each control.

Spots or dotted lines/stripes appear.

Caused by neon signs, high-voltage power lines, CB transmitter, other vehicle's ignition plugs, etc.

-Change the location of your vehicle.

The display angle cannot be adjusted or the adjustment screen does not appear.

Mechanism error.

-Press the OPEN/CLOSE button to stow away the display, and raise the display again.

*The fluorescent tube replacement is not free of charge even within the warranty period, for the tube is an article of consumption.

Specifications

MONITOR SECTION

Screen Size

7.0"

LCD Type

Transparent type TN LCD

Operation System

TFT active matrix

Number of Picture Elements

336,960 pcs. (1,440 x 234)

Effective Number of

 

Picture Elements

99.99% or more

Illumination System

Cold cathode

 

fluorescent tube

AV-INTERFACE UNIT SECTION

S/N Ratio

 

 

Video

45dB

 

Audio

55dB

 

Input Level

1 Vp-p (75Ω UNBALANCED)

 

Video

FR

Audio

500mV (RMS)

Output Level

1 Vp-p (75Ω UNBALANCED)

 

Video

 

Audio

500mV (RMS)

 

 

GENERAL

 

 

Power Requirement

14.4V DC (11-15 V allowable)

 

Operating temperature

+32ºF to +113º(0ºC to + 45ºC)

Weight

 

ES

(Monitor Section)

2.0 kg (4 lbs. 7 oz)

(AV-Interface Unit Section)

0.2 kg (7 oz)

 

CHASSIS SIZE (Monitor section)

 

Width

178 mm (7")

 

Height

50 mm (2")

 

 

Depth

165 mm (6-1/2")

 

CHASSIS SIZE

 

DE

(AV-Interface Unit section)

 

Width

106.6 mm (4-1/4")

 

Height

32 mm (1-1/4")

 

 

Depth

67.8 mm (2-11/16")

 

NOTES

Due to continuous product improvement, specifications and design are subject to change

without notice.

IT

• The LCD panel is manufactured using an

extremely high precision manufacturing

 

technology. Its effective pixel ratio is over

 

99.99%. This means that there is a possibility

 

that 0.01% of the pixels could be either always

 

ON or OFF.

 

 

 

 

SE

 

 

13-EN

Image 15
Contents TME-M790 Page Contents USE the Correct Ampere Rating When Replacing Fuses Precautions Raising the Monitor Using Face CoverBasic Operations Initial System Start-upSwitching the Source Turning Power On or OffAdjusting the Monitor Viewing Angle Adjusting the VolumeMode 2 Zoom Switching Display ModesViewing the switching display modes Mode 1 WideMode 4 Normal Mode 3 CinemaPress the SET UP button to finish adjustments Other Useful FeaturesAdjusting Brightness of Picture Adjusting Tint of PictureAuto Setting the Brightness of the BacklightAdjusting the Lowest Level of the Backlight Setting Automatic Opening Closing of MonitorNAV Setting the External Device Interrupt ModeSelecting Rear Monitor LinkTurning Sound Guide Function On or Off Switching the Opening ScreenSwitching the Video Screen Using the External Input Terminal12-EN Specifications InformationCase of Difficulty Do not Splice Into Electrical Cables Installation and ConnectionsPrecautions Installation Place of installationTo install using the vehicles genuine bracket If the ACC power supply is not available TME-M790TME-M790 Monitor Ground Lead Black ConnectionsConnect to the vehicle’s foot brake lead or brake lamp lead Parking Brake Lead Yellow/BlueVideo Output Terminal Audio Output ConnectorRGB Output Connector System ConnectionsPage Limitation DES Garanties Tacites Numéros Dappel DU Service À LA ClienteleProduits Couvert PAR LA Garantie Durée DE LA GarantieWhat is not Covered Length of WarrantyLifetime Tape Head Warranty What is Covered