Alpine TME-M790 owner manual Installation, Place of installation

Page 18

Installation and Connections

Installation

3

Installing the Monitor

• Place of installation

Before determining the position of installation, check that the display will not hamper gear shifting when it is opened and closed in that position.

NOTE

Install at an angle of within 30 degress from the horizontal.

1

Mounting Sleeve

Dashboard

Mounting Bracket

 

(Included)

 

(Included)

 

TME-M790

 

Screws(M4x5) (Included)

Lock Pin

Slide the TME-M790 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Supplied Front Frame.

Removal

1Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

2Pull the unit out, keeping it unlocked as you do so.

Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard. Install the supplied bracket to the monitor.

<JAPANESE CAR>

To install using the vehicle's genuine bracket

TME-M790

Ground Lead

2

Hex Nut (M5)

Ground Lead

Chassis

Screw

Metal Mounting Strap

Bolt Stud

TME-M790

Front Frame (Included)

Screws (M4x5)

Mounting Bracket

Reinforce the monitor with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw () already attached to the vehicle’s chassis.

NOTE

For the screw marked , use an appropriate screw for the chosen mounting location.

16-EN

Page 17 Page 19
Image 18
Page 17 Page 19
Contents TME-M790 Page Contents USE the Correct Ampere Rating When Replacing Fuses Precautions Initial System Start-up Using Face CoverBasic Operations Raising the MonitorAdjusting the Volume Turning Power On or OffAdjusting the Monitor Viewing Angle Switching the SourceMode 1 Wide Switching Display ModesViewing the switching display modes Mode 2 ZoomMode 3 Cinema Mode 4 NormalAdjusting Tint of Picture Other Useful FeaturesAdjusting Brightness of Picture Press the SET UP button to finish adjustmentsSetting Automatic Opening Closing of Monitor Setting the Brightness of the BacklightAdjusting the Lowest Level of the Backlight AutoLink Setting the External Device Interrupt ModeSelecting Rear Monitor NAVUsing the External Input Terminal Switching the Opening ScreenSwitching the Video Screen Turning Sound Guide Function On or Off12-EN Specifications InformationCase of Difficulty Installation and Connections Do not Splice Into Electrical CablesPrecautions Installation Place of installationTo install using the vehicles genuine bracket If the ACC power supply is not available TME-M790TME-M790 Monitor Parking Brake Lead Yellow/Blue ConnectionsConnect to the vehicle’s foot brake lead or brake lamp lead Ground Lead BlackSystem Connections Audio Output ConnectorRGB Output Connector Video Output TerminalPage Durée DE LA Garantie Numéros Dappel DU Service À LA ClienteleProduits Couvert PAR LA Garantie Limitation DES Garanties TacitesWhat is Covered Length of WarrantyLifetime Tape Head Warranty What is not Covered
Top Page Image Contents