Alpine TME-M790 owner manual Turning Power On or Off, Selecting the Monitor Opening Angle

Turning Power On or Off

1 Press the PWR (Power) button to turn on the unit. The opening screen appears automatically.

2 Press the PWR (Power) button again to turn off the unit.

NOTES

•The TME-M790 draws minimal current even when its power switch is turned off. If the switched power (ignition) lead of the TME- M790 is connected directly to the positive (+) post of the vehicle's battery, the battery may be discharged. If this lead is unswitched, it must be disconnected from the battery post should the vehicle be left unused for an extended period of time.

An SPST (Single-Pole, Single-Throw) switch (sold separately) can be added to simplify this procedure. Then, you can simply place it in the OFF position when you leave the vehicle. Turn the SPST switch back ON before using the TME-M790. For connecting the SPST switch, refer to the Installation.

•Some operation of the unit cannot be performed while the vehicle is in motion. In this case, be sure to first stop your vehicle and apply the parking brake, then perform the operation.

•After turning the system off, a slight ghost of the image will remain temporarily. This is an effect peculiar to LCD technology and is normal.

•Under cold temperature conditions, the screen may lose contrast temporarily. After a short warm-up period, it will return to normal.

Selecting the Monitor Opening Angle

The monitor opening angle can be set in 2 positions.

1 Press and hold the OPEN/CLOSE button for at least 2 seconds while the monitor is being raised. Each press changes the monitor angle back or forth.

NOTE

When the OPEN/CLOSE button is pressed and held for at least 2 seconds when the neck angle is adjusted, the neck angle adjustment is canceled.

After doing this, adjust the display in the front/rear direction.

Adjusting the Monitor Viewing Angle

Adjust the monitor's angle for better visibility.

1 While viewing the screen that is shown press the

9or 8 button to adjust the display to the ideal viewing angle.

The display viewing angle can be adjusted between 40 and 105 degrees.

2 Press the 4 or 3 button to adjust the right-left viewing angle. It is possible to adjust the display viewing angle up to 15 degrees to the left or right.

Press and hold the OPEN/CLOSE button for at

least 2 seconds to cancel the neck angle FR adjustment.

NOTES
• The angle changes continuously if the 9 and 8
buttons or the 4 and 3 buttons are held down.
• If there are any obstructions to the monitor
when adjusting the angle, first remove the
obstruction and then readjust the angle.
• The screen color will vary when viewed at certain	ES
angles. Adjust the screen angle for the best viewing
position.

•If the voltage of the vehicle's battery power is low, the screen may blink when the screen angle is changed. This is normal and not a malfunction.

•The adjusted angle is stored in the memory.

Adjusting the Volume

1 Press the	or		DE
		button to adjust the volume.

NOTE

The volume changes continuously if the or button is held down.

Switching the Source

1 Press the AUX button. Each press of the button IT will cycle through the modes as follows:

NAVIGATION AUX1 AUX2

SE

5-EN