Configuring Communication
This information can be found in either the Workspace - System name > Define
Device section of the code that defines the properties for the panel, or in the Device
Addressing/Network Addresses section of the Tools > NetLinx Diagnostics dialog.
6.Set up the security and communication parameters between the wireless card and the target WAP by configuring the Wireless Settings section on this page. Refer to Step 2: Configure the Card’s Wireless Security Settings section on page 25 for detailed procedures to setup either a secure or insecure connection.
Wireless communication using a Static IP Address
1.From the Protected Setup page, press the Wireless Settings button to open the Wireless Settings page. Wireless communication is set within the IP Settings section of this page (FIG. 19).
Check with your System Administrator for a
2.Toggle the DHCP/Static field from the IP Settings section until the choice cycles to Static. The IP Address, Subnet Mask, and Gateway fields then turn red, noting that they are now user- editable.
3.Press the IP Address field to open a keyboard and enter the Static IP Address provided by the System Administrator. Press Done after entering the IP address information and repeat the same process for the Subnet Mask and Gateway fields.
4.Press the optional Host Name field to open the keyboard and enter the Host Name information. Press Done after assigning the
5.Press the Primary DNS field to open a Keyboard, enter the Primary DNS Address (provided by the System Administrator) and press Done when compete. Repeat this process for the Secondary DNS field.
6.Press the Domain field to open a Keyboard, enter the resolvable domain Address (this is provided by the System Administrator and equates to a unique Internet name for the panel), and press Done when complete.
7.Set up the security and communication parameters between the wireless card and the target WAP by configuring the Wireless Settings section on this page. Refer to the following section for detailed procedures to set up either a secure or unsecure connection.
22 |