AOC P/N : 41A50-144 Circuit-Description, OSD-INDEX Explanation, Input not Support, Main-Frame

Page 11

5.CIRCUIT-DESCRIPTION

5-1 SPECIAL FUNCTION with PRESS-KEY

A). press Menu button during 2 seconds along with plug-in the DC Power cord:

That operation will set the monitor into “Factory- mode”, in Factory mode we can do the White balance adjustment with RS232 , and view the Backlight counter (this counter is use to record the panel activate hours ,for convenient the maintainer to check the panel backlight life time)

In Factory mode, OSD-screen will locate in left top of screen.

Press POWER-button off to on once will quit from factory mode and back to user-mode.

B). Press both Left & Right button along with Power button off to on once will activate the OSD-LOCK function, repeat this procedure will disable OSD-LOCK

In OSD-LOCK function, all OSD function will be lock , except Contrast and Brighness

OSD-INDEX EXPLANATION

1.CABLE NOT CONNECTED: Signal-cable not connected.

2.INPUT NOT SUPPORT:

a.INPUT frequency out of range: H > 81kHz, v > 75Hz or H < 28kHz, v < 55Hz

b.INPUT frequency out of VESA-spec. (out of tolerance too far)

3.UNSUPPORT mode, try different Video-card Setting:

Input frequency out of tolerance, but still can catch-up by our system (if this message show, that means, this is new-user mode, AUTO-CONFIG will disable)

5-2 THE Different on MAINBOARD or other ACCESSORY when using different PANEL type

1). The MCU software should be change

example : for CHI-MEI panel , the MCU part-number is 56A-1125-61-M for Hyundai panel , the MCU part-number is 56A-1125-61-Y

and the other ACCESSORY when use different panel type should be change as following: 1). The INVERTER module for CHI-MEI panel part-number is 79AL17-1-S

for Hyundai panel the INVERTER part number is 79A-L17-3-S

2). The cable to Panel side for CHI-MEI panel part number is 95A8018-30-1 for HYUNDAI panel is 95A8018-30-3

3). The Dsub cable for CHI-MEI is 89A-174D-5BF-GLF, for Hyundai is 89A-174-L17-3.

4). The Mechanical accessory is change or adding as follow;

 

CHI-MEI PANEL M170E1

Hyundai PANELHT17E11-100

MAIN-FRAME

15A5684-1

15A5705-1

Panel

750ALCD170-3

750ALCD170-4

10

Image 11
Contents Spectrum Series SEP Table of Contents LCD-PANEL Specifications for LCD MonitorGeneral specifications AC-IN Adapter Monitor Block DiagramInterface Connectors LCD Monitor DescriptionStorage Precautions Precautions and NoticesAssembly Precaution Operating PrecautionsPIN no Description RED Operating InstructionsAdjustment Method AdjustmentAdjustment Conditions and Precautions Adjust 6500 color-temperature Front Panel Control Knobs CHI-MEI Panel M170E1 CIRCUIT-DESCRIPTIONOSD-INDEX Explanation Input not SupportMODULE-TPYE Component SIMPLE-INTRODUCTION about LM700 chipsetPanel Clear factory mode flag Power-On Subrotine ChartSoftware Flow Chart SET factory mode flagII. Main Subrotine Loop No Screen Appear Interface-Board Trouble-Shooting chartMainboard PANEL-POWER CircuitU200-DATA Output Check Oscillator Block as above Keyboard Block check POWER-BLOCK check END Panel Luminance WAS Down There is an interferences in DOS ModeCorporation Inverter -MODULE Spec &Trouble Shooting ChartFunction Load Circuit M P O C O R P O R a T I O N Trouble Shooting of CHI-MEI Inverter DIVTL0037-D42 Part List Part Part Number QTY Description Supplier Remark Name Trouble Shooting Hight Voltage Protection Enbale Abnormality Transformer Abnormality Check U101 PIN4NO Freq ~70KHZ Part number 80AL17-1-CH Black, 80AL17-2-CH WhitePage Reference Part Quantity Cat.NO IV. Adapter BOM List Part no AL15-2-LIPCB PCB for CH-1205 Revd PCS For Front Heatsink No Voice Output AUDIO-MODULE Trouble shooting chartII. Sound Distortion Audio BOMGMZAN1 Name Description Pin DescriptionAnalog-to-Digital Converter PIN #Host Interface HIF / External On-Screen Display Clock Recovery / Time Base Conversion TFT TFT Panel InterfacePIN # Name Description 2pxl/clk 1pxl/clkTest Pins Typical Stand-alone Configuration System-level Block DiagramZoom Operating ModesNative Slow DclkSource Stand Alone DownscalingDestination Stand Alone Overall Architecture Clock Recovery CircuitFunctional Description Clock Recovery Circuit Minimum Typical Maximum Clock Recovery CharacteristicsSampling Phase Adjustment Source Timing GeneratorPin Connection for RGB Input with Composite Sync ADC CharacteristicsAnalog-to-Digital Converter 2.3.1 Pin Connection Pin Connection for RGB Input with Hsync/VsyncSource Timing Measurement Sync. Signal SupportDisplay Mode Support Input Timing MeasurementIRQ-Generation Conditions IRQ Event Remark IRQ ControllerData Path RGB Offset TFT Panel Interface Timing SpecificationScaling Filter Gamma TablePCLKB*4 Pclk *1Hsync width in TFT Vsync width and display position in TFTHorizontal size in TFT One pixel per clock mode in TFT Power ManagerState 3 Panel Fully Active State 0 Power OffState 1 Power On State 2 Panel Drive EnabledValue 4 bits Drive Strength in mA Panel Interface Drive StrengthHost Interface Panel Interface Pad Drive StrengthSerial Communication Protocol Timing Diagram of the gmZAN1 Serial CommunicationOn-Screen Display Control GmZAN1 Serial Channel Specification Parameter Min Typ MaxMulti-Function Bus MFB On-Chip OSD Controller OSD Color MapTclk Input Tclk SpecificationPvdd Electrical CharacteristicsDC Electrical Characteristic Parameter Min Typ Max Absolute Ratings Parameter Min Typ MaxMechanical of Cabinet Front DIS-ASSEMBLY T780KMGHBAA0A Specification Parts List of CabinetParts List of Cabinet continue Location CBPC780GM Specification Parts List of Conversion BoardLocation AI780GM Specification Location AI780GM SMD EC 22UF 16V 85C Csize KEPC780EK Parts List of KEY PC BoardParts List of Audio Board Parts List of DC-POWER BoardInverter Module Power System and Consumption CurrentAdapter Module PCB Layout TOP-LEVEL Flow Schematic DiagramII. GMZAN1 Block Lvds Block MCU Block Power Block KBL405G Adapter Schematic CH-1205C1,C2,C4 --- 1uF/50V

P/N : 41A50-144 specifications

The AOC P/N: 41A50-144 is a versatile and high-performing monitor that caters to both professional and casual users. With its sleek design and array of features, this model embodies the epitome of modern display technology.

One of the standout characteristics of the AOC 41A50-144 is its impressive display resolution. Equipped with a 1920 x 1080 pixels Full HD panel, it delivers sharp, vibrant images and ensures that text and graphics appear crisp and clear. The monitor boasts a wide viewing angle that allows for consistent color reproduction, making it perfect for collaborative workspaces or multi-screen setups.

In terms of refresh rates, the AOC 41A50-144 supports a 144Hz refresh rate, catering exceptionally well to gamers and media consumers who seek responsive performance. This high refresh rate reduces motion blur, providing a smoother experience during fast-paced gaming sessions or action-packed videos. Coupled with a 1ms response time, this monitor minimizes ghosting and lag, delivering a seamless visual experience.

The monitor utilizes advanced technologies to enhance the viewing experience further. One notable feature is AMD FreeSync support, which synchronizes the monitor's refresh rate with the GPU's frame rate, effectively eliminating screen tearing and stuttering during gameplay. This leads to a more immersive experience and ultimately gives gamers a competitive edge.

Another critical aspect of the AOC 41A50-144 is its connectivity options. It comes with multiple ports including HDMI, DisplayPort, and VGA, making it compatible with a wide range of devices. This versatility ensures that users can easily connect their computers, gaming consoles, or multimedia players without any hassle.

The AOC 41A50-144 also places importance on user comfort. It incorporates features like flicker-free technology and a low blue light mode to reduce eye strain during extended use. This focus on ergonomics allows for a more enjoyable viewing experience, regardless of the tasks at hand.

Overall, the AOC P/N: 41A50-144 combines high-performance, advanced technologies, and user-centered design. Whether for gaming, professional tasks, or entertainment purposes, this monitor stands out as a reliable and efficient solution that meets the demands of various users. Its features and specifications make it a compelling choice for anyone looking to enhance their display setup.