Elo TouchSystems 1528L user manual SW200095 Rev A, Page 37

Page 37

This equipment has been tested to the requirements for the CE Mark as required by Low Voltage Directive (LVD) 2006/95/EC indicated in European Standard EN60950-1 and the EMC Directive 2004/108/EC indicated in European Standard EN55022, EN61000-3-2, EN61000-3-3 and EN55024.

D)General Information to all Users: This equipment generates, uses and can radiate radio frequency energy. If not installed and used according to this manual the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to site-specific factors.

1)In order to meet emission and immunity requirements, the user must observe the following:

a)Use only the provided I/O cables to connect this digital device with any computer.

b)To ensure compliance, use only the provided manufacturer’s approved power cord.

c)The user is cautioned that changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

2)If this equipment appears to cause interference with radio or television reception, or any other device:

a)Verify as an emission source by turning the equipment off and on.

b)If you determine that this equipment is causing the interference, try to correct the interference by using one or more of the following measures:

i)Move the digital device away from the affected receiver.

ii)Reposition (turn) the digital device with respect to the affected receiver.

iii)Reorient the affected receiver’s antenna.

iv)Plug the digital device into a different AC outlet so the digital device and the receiver are on different branch circuits.

v)Disconnect and remove any I/O cables that the digital device does not use. (Unterminated I/O cables are a potential source of high RF emission levels.)

vi)Plug the digital device into only a grounded outlet receptacle.

Do not use AC adapter plugs. (Removing or cutting the power cord ground may increase RF emission levels and may also present a lethal shock hazard to the user.)

If you need additional help, consult your dealer, manufacturer, or an experienced radio or television technician.

User Manual: 1528L

SW200095 Rev A, Page 37 of 39

Image 37
Contents Elo Touch Solutions 1528L Touchmonitors Trademark Acknowledgments DisclaimerSW200095 Rev A, Page 3 Critical functions are Environmental conditions for transport and storage ClassificationEMC Guidance Symbol DescriptionSW200095 Rev A, Page 7 Portable and mobile RF communications equipment Separation distance according to frequency of transmitter Table of Contents External Medical Grade Power Adapter LCD Monitor Performance FeaturesIntroduction Product DescriptionUnpacking Your Touchmonitor Installation and SetupFront View Rear View Product OverviewSide View Kensington Lock Remove the Cable Cover USB Interface ConnectionSW200095 Rev A, Page 16 Replace the Cable Cover Installing the Touch Driver SoftwareOptimizing the LCD Monitor Installing the USB Touch Driver Operation About Touchmonitor AdjustmentsControls and Adjustment Phase Recall DefaultsOSD Timeout Auto AdjustGeneral Power Saving Mode Power LED Monitor & Power SavingPower Saving Indicator Mode Consumption Monitor Angle desktop onlySolutions to Common Problems TroubleshootingProblem Suggestions Input Video 15.0 LCD Native ResolutionVGA Svga XGA Touchmonitor Safety Waste Electrical and Electronic EquipmentWEEE Directive Care and Handling of Your TouchmonitorResolution Type Scan KHz Scan Hz Polarity Technical SpecificationsDisplay Modes Monitor ModesDimensions H x W Weight Net Certifications Value 1528L Touch Display SpecificationsHumidity non- condensing North America Power Adapter Cord SelectionEquivalent Types Cert Country Agency Mark Cord selection for other than North AmericaHAR Flexible Cord Mechanical Light Transmission per Astm D1003 Visual ResolutionOptical AccuTouch resistive Technology Touchscreen SpecificationsElectrical CarollTouch infrared Technology Touchscreen SpecificationsEnvironmental DurabilityReplacement Parts Part Number Contact Elo Touch SolutionsContact Elo TouchSystems Regulatory Information Electrical Safety InformationII. Emissions and Immunity Information SW200095 Rev A, Page 37 Warranty Check out Elo’s Website Getting in Touch with Elo
Related manuals
Manual 2 pages 43.31 Kb