Installing the USB Touch Driver

Additional drivers and driver information for other operating systems (including Macintosh and Linux) are available on the Elo TouchSystems web site at www.elotouch.com.

Your Elo USB touchmonitor is “plug-and-play” compliant. Information on the video capabilities of your touchmonitor is sent to your video monitor adapter when Windows starts. If Windows detects your touchmonitor, follow the instructions on the screen to install a generic plug-and-play monitor. Refer to the appropriate section below for driver installation instructions.

Installing the USB Touch Driver for Windows XP, Windows 2000, Windows Me and Windows 98

Insert the TouchTools CD-ROM in your computer’s CD-ROM drive.

If Windows XP, Windows 2000, Windows 98, or Windows Me starts the Add New Hardware Wizard, then:

1.Choose Next. Select “Search for the best driver for your device (Recommended)” and choose Next.

2.When a list of search locations is monitored, place a checkmark on “Specify a location” and use Browse to select the \EloUSB directory on the TouchTools CD- ROM.

3.Choose Next. Once the Elo TouchSystems USB touchscreen driver has been detected, choose Next again.

4.You will see several files being copied. Insert your Windows 98 CD if prompted. Choose Finish.

If Windows XP, Windows 2000, Windows 98, or Windows Me does not start the Add New Hardware Wizard:

NOTE: For Windows XP and Windows 2000, you must have administrator access rights to install the driver.

5.If the AutoStart feature for your CD-ROM drive is active, the system automatically detects the CD and starts the setup program.

6.Follow the directions on the screen to complete the driver setup for your version of Windows.

If the AutoStart feature is not active:

1.Click Start > Run.

2.Click the Browse button to locate the EloCd.exe program on the CD-ROM.

3.Click Open, then OK to run EloCd.exe.

Follow the directions on the screen to complete the driver setup for your version of Windows.

User Manual: 1528L

SW200095 Rev A, Page 18 of 39