Blaupunkt Tokyo RDM 169 KeyCard theft protection system, Putting the unit into operation

KeyCard theft protection system

This car radio comes equipped with two Key- Cards.

If you have lost your KeyCard or if it was damaged, you can buy a new one from your specialized dealer.

If you use two KeyCards, the settings stored on the first card will be transmitted to the second. However, you can individually store the following functions:

Preset button assignments, bass, treble, balance and fader settings, loudness, beep volume, LOW-EQ and HIGH-EQ.

In addition, the settings activated before the radio is switched off, such as the band, sta- tion, AF, REG ON/OFF, SCANTIME, seek tuning sensitivity, ON VOL and SHARX will also remained stored.

This ensures that you will find your basic settings re-adjusted automatically as soon as you have inserted your KeyCard.

Putting the unit into operation

•Turn on the set with ON.

To insert the KeyCard, unlock the operating panel by

•pressing 1, the operating panel will fold down.

•Insert the KeyCard with the contacts facing down as shown in the illustra- tion (arrow 1).

2

1

3

•Push the card in the direction of the ar- row (2) and lock the operating panel back into position (arrow 3).

The car radio is now ready for operation.

If a wrong KeyCard is inserted, then “CARD ERR” will appear in the display.

The system will switch off after approximate- ly ten seconds.

If another card type is inserted (e.g. phone or credit card), the display will show “WRONG KC” for approximately two sec- onds.

Remove the wrong card and insert the cor- rect KeyCard.

•Press ON to turn on the set.

Removing the KeyCard

To unlock the operating panel:

•Press 1, the operating panel will fold down forwards.

•Push the card in to the right as far as possible and remove it to the front.

•Push the operating panel back into po- sition.

For safety’s sake, the operating panel must remain locked when the vehicle is in motion.

When you leave the vehicle, un- lock the panel and remove the KeyCard to protect the equipment against theft.

“Training” a KeyCard/Replacing a KeyCard

When the unit is in operation with the first KeyCard, you can “train” another one to be also used with the set.

If you want to “train” a KeyCard:

•Insert the first KeyCard and turn on the set.

•Press the DSC button and press / to select “LEARN KC”.

•Press << or >>.

The display will switch to “CHANGE”.

ENGLISH

13